Black & Decker CS1012 Manuel d'instructions télécharger pdf (Page 9)

9

• While keeping the saw in this position,

unplug the saw and loosen the kerf

plate on the saw shoe.

• Align the 0° mark (22) on the kerf plate

with the cutting line. When adjusting

for 45° miter cuts, align the 45° mark

(23) on the kerf plate with the cutting

line.

• Secure the kerf plate using the screw

(24).

SAWING

WARNING: To reduce the risk of

serious personal injury,always hold the

tool with both hands.

• Let the blade run freely for a few

seconds before starting the cut.

• Apply only a gentle pressure to the tool

while performing the cut.

• Work with the shoe pressed against

the workpiece.

HINTS FOR OPTIMUM USE

• As some splintering along the line of

cut on the top side of the workpiece

cannot be avoided, cut on the side

where splintering is acceptable.

• Where splintering is to be minimized,

e.g. when cutting laminates, clamp a

piece of plywood onto the top of the

workpiece.

POCKET CUTTING (FIG.12)

POCKET CUTTING IS USED TO CUT A

HOLE IN A PIECE OF MATERIAL

WITHOUT CUTTING FROM THE SIDE.

• Measure and mark work.

• Tilt saw forward and rest front of the

shoe on material to be cut. Align so

that cut will begin at the back of the

drawn rectangle shown in figure 12.

• Using the retracting lever, retract blade

guard to an upward position, with the

blade just clearing the material, start

motor and gradually lower the saw into

the material.

WARNING: As blade starts cutting the

material, release the retracting lever

immediately.

• Never tie the blade guard in a raised

position.

• When the shoe rests flat on the

material being cut, complete the cut in

forward direction.

• Allow the blade to come to a complete

stop before lifting saw from material.

• When starting each new cut, repeat the

above steps.

WRENCH STORAGE (FIG.13)

The spanner wrench (8) can be stored

on the saw shoe as shown in figure 13.

MAINTENANCE

Use only mild soap and damp cloth to

clean the tool. Never let any liquid get

inside the tool; never immerse any part of

the tool into a liquid.

IMPORTANT: To assure product

SAFETY and RELIABILITY, repairs,

maintenance and adjustment (other than

those listed in this manual) should be

performed by authorized service centers

or other qualified service organizations,

always using identical replacement parts.

LUBRICATION

Black & Decker tools are properly

lubricated at the factory and are ready for

use.

11

23

22

24

8

12

13

90511917 CS1012 5/7/07 9:32 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Commentaires sur ces manuels

Pas de commentaire