Black & Decker CS1012 Manuel d'instructions télécharger pdf (Page 5)

5

hazardous situation which, if not avoided,

may result in property damage.

SE THESE INSTRUCTIONS

WARNING: Some dust created by

power sanding, sawing, grinding,

drilling, and other construction

activities contains chemicals known

to cause cancer, birth defects or other

reproductive harm. Some examples

of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and

cement and other masonry products,

• arsenic and chromium from

chemically-treated lumber (CCA).

Your risk from these exposures varies,

depending on how often you do this type

of work. To reduce your exposure to these

chemicals: work in a well ventilated area,

and work with approved safety equipment,

such as those dust masks that are

specially designed to filter out microscopic

particles.

• Avoid prolonged contact with dust

from power sanding, sawing,

grinding, drilling, and other

construction activities. Wear

protective clothing and wash

exposed areas with soap and water.

Allowing dust to get into your mouth,

eyes, or lay on the skin may promote

absorption of harmful chemicals.

WARNING: Use of this tool can

generate and/or disburse dust, which

may cause serious and permanent

respiratory or other injury. Always use

NIOSH/OSHA approved respiratory

protection appropriate for the dust

exposure. Direct particles away from

face and body.

CAUTION: Wear appropriate hearing

protection during use. Under some

conditions and duration of use,

noise from this product may

contribute to hearing loss.

• Snagging the lower guard on a

surface below the material being cut

can momentarily reduce operator

control. The saw can lift partially out of

the cut increasing the chance of blade

twist. Ensure there is sufficient

clearance under the workpiece.

• When necessary to raise lower guard

manually, use the retracting lever.

• KEEP THE BLADES CLEAN AND

SHARP. Sharp blades minimize stalling

and kickback. The use of dull and/or dirty

blades can increase the saw loading

causing the operator to push harder

which promotes twisting.

DANGER: LACERATION HAZARD.

KEEP HANDS AWAY FROM CUTTING

AREA. Keep hands away from blades.

Never place hands in front of or behind

the path of the blade while cutting. Do

not reach underneath work while blade

is rotating. Do not attempt to remove cut

material when blade is moving.

• SUPPORT LARGE PANELS. Large

panels must be supported as shown

(figure 1) in this manual to minimize the

risk of blade pinching and kickback.

Material supported only at the ends

(figure 2) will lead to blade pinching.

When cutting operation requires the

resting of the saw on the workpiece, the

saw shall be rested on the larger portion

and the smaller piece cut off.

• USE ONLY CORRECT BLADES AND

BLADE ASSEMBLY COMPONENTS

WHEN MOUNTING BLADES. Do not

use blades with incorrect size holes.

Never use defective or incorrect blade

washers or bolts. Follow blade assembly

procedures.

• ADJUSTMENTS. Before cutting be sure

depth and bevel adjustments are tight.

• SUPPORT AND SECURE THE WORK

PROPERLY. Insure that the material to

be cut is clamped (figure 3) and solidly

supported and balanced on a strong,

stable and level work surface. Support

the work so that the wide portion of the

saw shoe is on the portion of the

material that doesn’t fall after the cut is

made. Never hold cut off piece by hand

1

2

ADDITIONAL SAFETY RULES:

CIRCULAR SAWS

90511917 CS1012 5/7/07 9:32 AM Page 5

1 2 3 4 5 6 7 8 9 10 ... 31 32

Commentaires sur ces manuels

Pas de commentaire