Black & Decker BT2500 Manuel d'utilisateur télécharger pdf

READ AND UNDERSTAND ALL OF THE SAFETY INSTRUCTIONS IN YOUR TABLE SAW INSTRUCTION MANUAL BEFORE ATTEMPTING

TO USE THIS ACCESSORY.

NOTE: This Dado Insert Plate is for use ONLY with the Black & Decker BT2500 10” Table Saw.

Remove standard insert plate and blade guard.

CAUTION: UNPLUG THE TABLE SAW.

• Remove the standard throat plate by loosening the phillips head screw in the front of the plate (Fig.1) and lifting the plate out.

• Remove the blade guard by loosening the two hex nuts to the right of the guard (Fig. 2 (A)). The nuts do not need to be removed, only loos-

ened enough to free the blade guard. Lift the guard out of the mount.

Remove the Blade

• Raise the saw blade approximately one inch above the table top.

• Place one blade wrench provided with your saw, onto the flats on the blade arbor. Place the other blade wrench onto the arbor nut and

loosen the arbor nut by turning counterclockwise (Figure 3). Place saw blade to its highest position and remove the arbor nut, flange and

blade.

Install Dado Cutter

CAUTION: Do not attempt to stack dado blades thicker than 13/16" (20.6mm). For any dado stack greater than 1/2” (12.7mm), remove the

outer washer and do not use. Place the dado stack on the spindle. Lower the blade and place one blade wrench onto the flats on the blade

arbor. Place the other blade wrench onto the arbor nut. Tighten the arbor nut by turning clockwise. Do not use dado blades larger than 8"

(203mm) diameter.

Install the Dado Insert

• The dado insert, like the standard insert, uses four adjustment screws which raise or lower the insert plate. When properly adjusted, the front

of the insert should be flush or slightly below the surface of the table top, the rear of the insert should be flush or slightly above the table top.

Tighten the phillips head screw in the front of the plate after installing and adjusting the insert. Be sure to rotate the dado cutter one full revo-

lution to insure that it clears the dado insert before plugging in the saw and attempting a cut.

CAUTION:

• Do not attempt to bevel cut while using the dado insert.

• Please read and understand the dado cutting instruction included in the manual supplied with your table saw before attempting a cut.

• Do not place your hands on the wood above the blade, use a push stick.

WARNING: When you have completed your dado cutting and wish to return to using the standard blade, remember to re-install the blade

guard and standard insert plate before operating the saw.

FIG. 2

FIG. 1

Cat #BT510 Form # 606145-00

FIG. 3

INSTRUCTION MANUAL

1 2

INSTRUCTION MANUAL 1

Résumé du contenu

Page 1 - INSTRUCTION MANUAL

READ AND UNDERSTAND ALL OF THE SAFETY INSTRUCTIONS IN YOUR TABLE SAW INSTRUCTION MANUAL BEFORE ATTEMPTINGTO USE THIS ACCESSORY.NOTE: This Dado Insert

Page 2

Plaquette amovible pour lame à rainer (dado) BT510LIRE ET COMPRENDRE TOUTES LES CONSIGNES DE SÉCURITÉ DU GUIDE D’UTILISATION DE LA SCIE D’ÉTABLI AVANT

Commentaires sur ces manuels

Pas de commentaire

Black & Decker BT2500 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Scies circulaires Black & Decker BT2500. 606145-00 BT510 Throat Plate [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Black & Decker BT2500