Black & Decker CS1012 Manuel d'instructions télécharger pdf (Page 6)

6

(figure 4 ). KICKBACK from blade pinch

can result. Keep both hands on saw at all

times.

• STAY ALERT AND EXERCISE

CONTROL. Keep body positioned to one

side of blade. Always maintain a firm grip

and control of saw with both hands. Do

not change hand grip or body position

while saw is running. Take precaution to

avoid injury from cut off pieces and other

falling material during operation.

DANGER: RELEASE SWITCH

IMMEDIATELY IF BLADE BINDS OR

SAW STALLS

GUARD AGAINST KICKBACK

• KICKBACK CAN BE CAUSED BY the

saw blade becoming pinched, twisted or

bound while cutting, or when the saw

stalls. When the blade becomes twisted

or misaligned in the cut, the teeth at the

back edge of the blade can dig into the

top surface of the wood causing the

blade to climb out of the cut and move

suddenly back toward the operator.

TO REDUCE THE RISK OF KICKBACK

• Keep a firm grip on saw with both hands

at all times.

• Stay alert – exercise control.

• Support long overhanging materials. As

the material is cut and weakens, it will

sag, causing a pinched blade.

• Support large panels as shown (Fig. 1).

Material supported only at the ends (Fig.

2) will lead to blade pinching.

• Avoid sawing overhead. Material can

sag and will pinch blade.

• Keep blades sharp and clean.

• Use fence or straight edge guide when

ripping. Be careful as the cut off strip can

sag or twist, closing the cut and pinching

the blade, leading to KICKBACK.

• Don’t force tool. Wood variables such as

knots, hardness, toughness, wetness,

pressure treated and freshly cut green

lumber can heavily load the saw which

can lead to stalling. Push the saw slower

when this occurs.

• Don’t remove saw from work during a

cut while the blade is moving.

• Allow saw to reach full speed before

blade contacts material to be cut.

Starting the saw with the blade against

the work or pushed forward into cut can

lead to stalling or sudden backward

movement of saw.

• Never attempt to lift saw when making a

bevel cut. This leads to blade binding

and stalling.

• Always secure work to prevent

workpiece movement during cut.

• Do not try to force saw back on line if

your cut begins to go off line. This can

cause KICKBACK. Stop saw and allow

blade to coast down to a stop. Withdraw

from cut and start a new cut on the line.

• Set depth adjustment of saw such that

one tooth of the blade projects below the

workpiece as shown in (figure 8).

• Do not back up a rotating blade in the

cut. Twisting the saw can cause the

back edge of the blade to dig into the

material, climb out of the work and run

back toward the operator.

• Avoid cutting nails. Inspect for and

remove all nails from lumber before

cutting.

The label on your tool may include the

following symbols.

V..............volts

mW..........milliwatts

nm ..........wavelength in nonometers

A..............amperes

Hz............hertz

W ............watts

min ..........minutes

............alternating current

........direct current

no ............no load speed

............Class II Construction

…/min......revolutions or

................reciprocation per minute

............earthing terminal

............safety alert symbol

MOTOR

Be sure your power supply agrees with

nameplate marking. 120 Volts AC means

your tool will operate on standard 60 Hz

3

4

90511917 CS1012 5/7/07 9:32 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire