Black & Decker LST1018 Manuel d'instructions télécharger pdf (Page 11)

• Slowly swing trimmer side-to-side as

shown in figure M.

• To convert for maintenance edging, turn off

the tool. As shown in figure N, hold the

trimmer with one hand by the auxiliary

handle, grasp the collar and push in

direction of arrow and rotate the trimmer

head until it stops, (half turn), release your

hand, (rotate clockwise when viewed from

the switch end). The tool is locked in the

edger position.

Rotate the wire edge guide forward and

down into place before edging, as shown

in figure O.

HEIGHT ADJUSTMENT

The overall height of the trimmer

can be adjusted by loosening the

lock collar and rotating it opposite to

the arrow shown in figure K. The

tubes can then be extended shorter

or longer. When the desired height

is achieved tighten the collar by

rotating in the direction shown in

figure K.

Operating Instructions

CAUTION: ALWAYS WEAR EYE PROTECTION.

CAUTION: Inspect area to be trimmed and remove any wire,

cord, or string-like objects which could become entangled in the

rotating line or spool. Be particularly careful to avoid any wire which

might be bent outwardly into the path of the tool, such as barbs at the

base of a chain link fence.

OPERATE THE

TRIMMER/EDGER

• To turn trimmer on, pull the lock out

button, shown in figure L, back

and, then squeeze the trigger

switch. To turn the tool off, release

the trigger.

Lock-out

Trigger Switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 51 52

Pas de commentaire

Black & Decker LST1018 Manuel d'instructions Page 11