Black & Decker LST1018 Manuel d'instructions télécharger pdf (Page 12)

• To operate as a maintenance edger,

position trimmer above sidewalk as

shown in figure P.

• Return to trimming position by turning

the tool off, push in direction of arrow

and rotating the trimmer head counter

clockwise until it stops. When using

the tool in the trimmer mode you may

choose to fold the wire edge guide up

out of the way

LINE FEEDING

Your trimmer uses .065 in. (1.65mm)

diameter nylon line to cut grass and weeds quickly and easily. In time,

the tip of the nylon line will become worn and the auto feed

mechanism will automatically feed and trim a fresh length of line.

The cutting line will wear faster if the cutting is done along sidewalks

or other abrasive surfaces or heavier weeds are being cut. The

automatic feed mechanism senses when more cutting line is needed

and feeds and trims the correct length of line whenever it is required.

You donʼt even have to think about it. Do not bump unit on ground in

attempt to feed line or for any other purpose.

REPLACING SPOOL/CLEARING

JAMS AND TANGLED LINES

From time to time, especially when

cutting thick or stalky weeds, the line

feeding hub may become clogged with

sap or other material and the line will

become jammed as a result. To clear

the jam, follow the steps listed below.

• Turn off the trimmer and remove the

battery.

• Press the release tabs on the line

spool cover, as shown in figure Q

and remove the cover by pulling it

straight off.

• Lift the spool of nylon line out of the hub and clear any broken line or

cutting debris from the spool area.

• In case of jams and tangled line

unwrap about one foot (30cm) of

line to ensure that it is undamaged.

If it is OK rewind it and insert the

line end through the eyelet in the

spool hub, as shown in figure R.

• Pull the line through the hole to

maintain tension while placing the

spool down into the hub with the

notched side exposed, as shown in

figure S.

• Press the spool down GENTLY

and rotate it until you feel it drop

into place.(When in place, thespool

will turn afew degreesleftand right

freely.)

• Snap the spool cover back on,

insert the battery and turn the tool

on. In a few seconds or less youʼll

hear the nylon line being cut

automatically to the proper length.

• For trouble free feeding and best results, only use Black & Decker

replacement spools with single 0.065 inch line. Black & Decker

replacement model number AF-100.

AF-100 Spool

RC-100-P

Cap

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LST1018 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker LST1018