10
ENGLISH
How to use the Auto Select™ dial (fi g. G)
This tool is fi tted with a unique Auto Select™ Dial (8) to set the speed and the pendulum blade action
for various cutting applications. To select the optimum speed and pendulum blade action for the type of
material being cut, turn the dial (8) as shown in the table below:
Icon Application Speed/
Pendulum
Blade Type
Kitchen work
surfaces, work
tops, laminate
board
Fast speed, No
pendulum
General wood
Scrolling/curves/
craftwork,
hardwoods,
decking, fl ooring
Fast speed, No
pendulum
Scrolling wood
General wood
Plywood and
wood panels
Fast speed,
medium
pendulum
General wood
General timber,
soft wood, fast
rip cutting
Fast speed, max
pendulum
General wood
Plastics,
Perspex, PVC
Medium speed,
medium
pendulum
General purpose
Sheet metal tin
plate, ceramic
tile, fi breglass
sheet
Low speed, No
pendulum
Metal or ceramic
or fi breglass
blade
Slow speed,
precision start
Slow speed, No
pendulum
Choose the
correct blade for
the application
Switching on and off
♦ To switch the tool on, press the on/off switch
(2).
♦ To switch the tool off, release the on/off switch
(2).
♦ For continuous operation, press the lock-on
button (1) and release the on/off switch (2).
♦ To switch the tool off when in continuous
operation, press the on/off switch (2) and
release it.
Sawing
Hold the tool fi rmly with both hands while cutting.
The shoe plate (7) should be held fi rmly against
the material being cut. This will help prevent the
saw from jumping, reduce vibration and minimise
blade breakage.
♦ Let the blade run freely for a few seconds
before starting the cut.
♦ Apply only a gentle pressure to the tool while
performing the cut.
Operating the laser (fi g. H - K) (‘L’ units only)
Installing the batteries (fi g. H)
Detach the laser module (14) from the jigsaw by
removing the screw (13) and pulling the laser
module forward. Insert two new 1.5 Volt AAA
alkaline batteries, making sure to match the (+)
and (-) terminals correctly. Re-attach the laser
module (14).
Adjusting the laser side-to-side (fi g. I)
Note: The laser is intended as a cutting aid and
does not guarantee a precise cut.
Warning! Do not adjust the laser with the jigsaw
plugged in.
♦ Use the laser adjustment screw (15) to align
the laser line with the saw blade if needed.
Commentaires sur ces manuels