Black & Decker NPP2018 Manuel d'instructions télécharger pdf (Page 12)

Pruning With the Pole Saw

Warning: When pruning trees:

• Guard Against Kickback which can result in

severe injury or death. See “KICKBACK”,

page 3 to avoid the risk of kickback.

• Do not overreach. Make sure your footing is

firm. Keep feet apart. Divide your weight evenly

on both feet.

• Use both hands to grip Pole Saw as shown

in figure 22. Use a firm grip. Thumbs and

fingers must wrap around Pole Saw handle and

pole. Keep fingers away from

sawdust exhaust chute shown in

figure 22a.

• Never operate while in a tree, in

any awkward position or on a

ladder or other unstable surface.

You may lose control of Pole Saw

causing severe injury.

Follow directions below to trim a tee.

1. Make sure Pole Saw is running at full speed before making a cut.

When starting a cut, place moving chain against limb. Hold Pole

Saw firmly in place to avoid

possible bouncing or skating

(sideways movement) of Pole

Saw.

2. Guide Pole Saw using light

pressure. Make first cut six inches

from tree trunk on underside of

limb. Use top of guide bar to make

this cut. Cut 1/3 through diameter

of limb. Then make the finish cut

from the top as shown in figure

23.

If you try to cut off thick branches

from the bottom, the branch may

close in and pinch the saw chain

in the cut. If you try to cut off thick

branches from the top, without a

shallow undercut, the branch may

splinter figure 24.

Do not force Pole Saw. The motor

will overload and can burn out. It

will do the job better and safer at

the rate for which it was intended.

3. Remove Pole Saw from cut while

it is running at full speed. Stop Pole Saw by releasing trigger.

Make sure chain has stopped before setting Pole Saw down.

Saw chain sharpness

The cutters will dull immediately if they touch the ground or a nail

while cutting.

Saw chain tension

This should be done regularly. Refer to page 8 “Adjusting Chain

Tension”.

Pole Saw Maintenance Section

Regular maintenance ensures a long effective life for the tool.

After every 10 minutes of use be sure to remove the battery (be

aware the chain and bar can be hot!) check the bar and chain for

correct tension and lubricate per pole saw instruction manual.

Use only mild soap and damp cloth to clean the tool. Never let any

liquid get inside the tool; never immerse any part of the tool into a

liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs,

maintenance and adjustment should be performed by authorized

service centers or other qualified service organizations, always using

identical replacement parts.

22a

625116-00 NPP2018 Pole 11/12/04 9:11 AM Page 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018