Black & Decker NPP2018 Manuel d'instructions Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 44
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
Disassembly
Detaching Saw Head Module
WARNING: Sharp moving blade. To prevent accidental
operation, insure that battery is disconnected from the handle
and that the protective scabbard is in place on the chain before
performing the following operations. Failure to do this could result
in serious personal injury.
When detaching the modules, whether it is in the two
module or three module mode, always detach the
saw head module first. To do this, rest the handle
module on the ground and grasp the center of the
saw head module with
one hand figure 17. Use
your other hand to loosen
the threaded sleeve
figure 18 and then pull
the two halves apart.
Repeat this process if the center extension
was attached.
Operating the Pole Saw
WARNING: Read and understand all
instructions. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious personal
injury.
Connecting the Battery
Place the battery in the tool as shown in
figure 19 and be certain that it is inserted
fully into the tool cavity until it “clicks” into
place. To remove the battery from the tool,
press down on the release button on the
back of the battery (figure 20) and slide
out.
10
20
17
18
19
Joining Center Extension to Saw Head Module and
Handle Module
Adding the extension (B) to the handle module (A) and saw head
module (C) creates a Pole Saw that is approximately 9 foot in length
as shown in figure 13.
To attach the middle module to the handle module and saw head
module:
1. Align the groove on the outside of the
coupling end of the handle module (A)
with the tongue on the inside of the
coupling end of the center extension (B).
See figure 14. Push the two sections
completely together.
2. Slide the threaded sleeve (6) (figure
15) on the center extension down as far
as possible and rotate the sleeve
clockwise until it stops and completely
covers the orange threads as shown in
figure 16.
3. Repeat steps 1 and 2 above to attach
the saw head module to the center
extension.
WARNING: Always check to make
sure that the sleeve is completely
threaded on and that the orange threads are no longer visible.
Not threading the sleeve completely on could result in the modules
becoming disconnected creating a hazardous condition.
Periodically check the connections to insure that no orange threads
are visible.
Groove
14
15
16
13
625116-00 NPP2018 Pole 11/12/04 9:11 AM Page 10
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Commentaires sur ces manuels

Pas de commentaire