Black & Decker NPP2018 Manuel d'instructions télécharger pdf (Page 6)

10. Use only one charger when charging.

11. Do not attempt to open the charger. There are no customer

serviceable parts inside. Return to any authorized Black & Decker

service center.

12. DO NOT incinerate the tool or battery even if they are severely

damaged or completely worn out. The batteries can explode in a

fire.

13. A small leakage of liquid from the battery cells may occur under

extreme usage, charging or temperature conditions. This does not

indicate a failure. However, if the outer seal is broken and this

leakage gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with clean water

for a minimum of 10 minutes and seek immediate medical

attention. MEDICAL NOTE: The liquid is a 25-35% solution of

potassium hydroxide.

Charging the Battery

THE BATTERY IS NOT FULLY CHARGED AT THE FACTORY.

BEFORE ATTEMPTING TO CHARGE THE BATTERY,

THOROUGHLY READ ALL OF THE SAFETY INSTRUCTIONS.

The charger is designed to use standard household 120 volt 60 Hz

power.

1. Plug the charger into any standard 120 Volt 60 Hz electrical

outlet. NOTE: Do not charge by means

of an engine generator or DC power

source. Use only 120V AC.

2. Slide the charger onto the battery as

shown in figure 1 and let the battery

charge initially for 9 hours. After the

initial charge, under normal usage, your

battery should be fully charged in 3 to 6

hours.

3. Unplug charger, and remove the battery.

Important Charging Notes

1. After normal usage, your battery should be fully charged in 3 to

6 hours. If the battery is run-down completely, it may take up to

6 hours to become fully charged. Your battery was sent from the

factory in an uncharged condition. Before attempting to use it, it

must be charged for at least 9 hours.

2. DO NOT charge the battery in an air temperature below 40°F

(4,5 °C) or above 105°F.(40,5 °C) This is important and will

prevent serious damage to the battery. Longest life and best

performance can be obtained if battery is charged when air

temperature is about 75°F.(24°C).

3. While charging, the charger may hum and become warm to

touch. This is a normal condition and does not indicate a

problem.

4. If the battery does not charge properly—(1) Check current at

receptacle by plugging in a lamp or other appliance. (2) Check

to see if receptacle is connected to a light switch which turns

power off when you turn out the lights. (3) Move charger and

battery to a surrounding air temperature of 40°F (4,5 °C) to

105°F.(40,5 °C) (4) If the receptacle and temperature are OK,

and you do not get proper charging, take or send the battery

and charger to your local Black & Decker service center. See

Tools Electric in yellow pages.

5. The battery should be recharged when it fails to produce

sufficient power on jobs which were easily done previously. DO

NOT CONTINUE using product with its battery pack in a

depleted condition.

6. To prolong battery life, avoid leaving the battery on charge for

extended periods of time (over 30 days without use). Although

overcharging is not a safety concern, it can significantly reduce

overall battery pack life.

7. The battery will reach optimum performance after being cycled 5

times during normal usage. There is no need to run the batteries

down completely before recharging. Normal usage is the best

method of discharging and recharging the batteries

625116-00 NPP2018 Pole 11/12/04 9:11 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'instructions Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018