Black & Decker NPP2018 Manuel d'instructions télécharger pdf (Page 9)

Chain Oiling

• A high quality bar and chain oil or

SAE30 weight motor oil should be used

for chain and bar lubrication. The use

of a vegetable based bar and chain oil

is recommended when pruning trees.

Mineral oil is not recommended

because it may harm trees. Never use

waste oil or very thick oil. These may

damage your chain saw.

• Lubricate the whole chain evenly

before each use as shown in figure 6.

Also lubricate the chain whenever replacing a fully discharged

battery with a fully charged one.

Transporting Pole Saw

• Always remove the battery pack from the

handle (figure 7) and cover the chain with the

scabbard (figure 8) when transporting the

Pole Saw. See page 5 for additional

information on transporting the battery.

Assembly

Joining Saw Head Module to 18V Handle Module

WARNING: Sharp moving blade. To prevent accidental

operation, insure that battery is disconnected from the handle

and that the protective scabbard is in place on the chain before

performing the following operations. Failure to do this could result

in serious personal injury.

The three modules which make up the 18V Pole Saw are keyed to

insure correct assembly. If a module does not smoothly attach to

another do not force fit.

Combining the handle module (A) to the saw head module (C)

creates a pole saw that is approximately 6 foot in length as shown in

figure 9.

To attach the handle module to the saw head module:

1. Align the groove on the outside of the coupling end of the handle

module (A) with the tongue on the

inside of the coupling end of the saw

head module (C). See figure 10. Push

the two sections completely together.

2. Slide the threaded sleeve (6) figure 11

on the saw head module down as far as

possible and rotate the sleeve clockwise

until it stops and completely covers the

orange threads as shown in figure 12.

WARNING: Always check to make

sure that the sleeve is completely

threaded on and that the orange

threads are no longer visible. Not

threading the sleeve completely on

could result in the modules becoming

disconnected creating a hazardous

condition. Periodically check the

connections to insure that no orange

threads are visible.

Groove

625116-00 NPP2018 Pole 11/12/04 9:11 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018