Black & Decker 395136-00 Manuel d'instructions télécharger pdf (Page 17)

If you have any questions, call 1-800-54-HOW-TO

PRETESTING WITH SCRAP MATERIAL IS EXTREMELY

IMPORTANT!

SPECIAL CUTS

NEVER MAKE ANY CUTS UNLESS THE MATERIAL IS SECURED

ON THE TABLE AND AGAINST THE FENCE.

ALUMINUM CUTTING (CARBIDE TIPPED BLADE ONLY)

Aluminum extrusions such as those used when making aluminum

screens and storm windows can easily be cut with your saw using the

proper blade designed for non-ferrous metal cutting. Position the

material so that you will be cutting the thinnest cross section, as

shown in Figure 14. Figure 15 illustrates the wrong way to cut these

extrusions. Use a wax lubricant when cutting aluminum such as

Johnson’s Stick Wax No.140. Apply the stick wax directly to the saw

blade before cutting. Never apply stick wax to a moving blade.

The wax, available at most hardware stores and industrial mill supply

houses, provides proper lubrication and keeps chips from adhering to

the blade.

Be sure to properly secure work. Certain workpieces, due to their

size, shape or surface finish, may require the use of a clamp, jig or

fixture to prevent movement during the cut.

BOWED MATERIAL

When cutting bowed material always position it as shown in Figure

16 and never like that shown in Figure 17. Positioning the material

incorrectly will cause it to pinch the blade near the completion of the

cut.

CUTTING PLASTIC PIPE AND OTHER ROUND CROSS-

SECTIONAL MATERIAL

Plastic pipe can be easily cut with your saw. It should be cut just like

INSTRUCTIONS FOR CUTTING CROWN MOLDING LAYING FLAT

AND USING THE COMPOUND FEATURES

1. Molding laying with broad back surface down flat on saw table

2. The settings below are for All Standard (U.S.) crown molding

with 52° and 38° angles.

BEVEL SETTING TYPE OF CUT

LEFT SIDE, INSIDE CORNER:

33.85° 1. Top of molding against fence

2. Miter table set right 31.62°

3. Save left end of cut

RIGHT SIDE, INSIDE CORNER:

33.85° 1. Bottom of molding against fence

2. Miter table set left 31.62°

3. Save left end of cut

LEFT SIDE, OUTSIDE CORNER:

33.85° 1. Bottom of molding against fence

2. Miter table set left 31.62°

3. Save right end of cut

RIGHT SIDE, OUTSIDE CORNER:

33.85° 1. Top of molding against fence

2. Miter table set right 31.62°

3. Save right end of cut

When setting bevel and miter angles for all compound miters,

remember that:

The angles presented for crown moldings are very precise and

difficult to set exactly. Since they can easily shift slightly and very few

rooms have exactly square corners, all settings should be tested on

scrap molding.

395136-00,03,BT1500 6/22/04 9:05 AM Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker 395136-00 Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker 395136-00