Black & Decker 395136-00 Manuel d'instructions télécharger pdf (Page 15)

If you have any questions, call 1-800-54-HOW-TO

material being cut, blade type, blade sharpness and rate of cut all

contribute to the quality of the cut.

When smoothest cuts are desired for molding and other precision

work, a sharp (60 tooth carbide) blade and a slower, even cutting rate

will produce the desired results.

Ensure that material does not creep while cutting, clamp it securely in

place. Always let the blade come to a full stop before raising arm.

If small fibers of wood still split out at the rear of the workpiece, stick a

piece of masking tape on the wood where the cut will be made. Saw

through the tape and carefully remove tape when finished.

Keep both feet firmly on the floor and maintain proper balance. As

you move the miter arm left and right, follow it and stand slightly to the

side of the saw blade. Sight through the guard louvers when following

a pencil line

CLAMPING THE WORKPIECE

Turn Off and Unplug Saw

If you cannot secure the workpiece on the table and against the fence

by hand (irregular shape, etc.) or your hand will be within 6” of the

blade, a clamp or fixture must be used.

Other convenient clamps such as spring, bar or C-clamps may be

appropriate for certain sizes and shapes of workpieces. Use care in

selecting and placing these clamps and make a dry run before

making the cut. The left fence may be adjusted to aid clamping.

SUPPORT FOR LONG PIECES

Turn Off and Unplug Saw

ALWAYS SUPPORT LONG PIECES

For best results, use an extension work support to extend the table

width of your saw. Support long workpieces using any convenient

THIS SAW. Do not use any abrasive blades.

CROSSCUTS

NOTE: Cutting of multiple pieces is not recommended, but can be

done safely by ensuring that each piece is held firmly against the

table and fence.

A crosscut is made by cutting wood across the grain at any angle. A

straight crosscut is made with the miter arm at the zero degree

position. Set the miter arm at zero, hold the wood on the table and

firmly against the fence. Turn on the saw by squeezing the trigger

switch.

When the saw comes up to speed (about 1 second) lower the arm

smoothly and slowly to cut through the wood. Let the blade come to a

full stop before raising arm.

Miter crosscuts are made with the miter arm at some angle other than

zero. This angle is often 45 degrees for making corners, but can be

set anywhere from zero to 47 degrees left or right. After selecting the

desired miter angle, be sure to tighten the miter clamp handle (4).

Make the cut as described above.

BEVEL CUTS

A bevel cut is a crosscut made with the saw blade at a bevel to the

wood. In order to set the bevel, loosen the bevel clamp knob (10) and

move the saw to the left as desired. (It is necessary to move the left

side of the fence to allow clearance). Once the desired bevel angle

has been set, tighten the bevel clamp knob firmly.

Bevel angles can be set from 2 degrees right to

47 degrees left and can be cut with the miter arm set between zero

and 47 degrees right or left.

QUALITY OF CUT

The smoothness of any cut depends on a number of variables. Things like

395136-00,03,BT1500 6/22/04 9:05 AM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker 395136-00 Manuel d'instructions Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker 395136-00