Black & Decker LST136 Manuel d'instructions télécharger pdf (Page 7)

LEAVING THE BATTERY IN THE CHARGER

The charger and battery pack can be left connected with the green

LED glowing indefinitely. The charger will keep the battery pack

fresh and fully charged.

IMPORTANT CHARGING NOTES

1. Longest life and best performance can be obtained if the battery

pack is charged when the air temperature is between 60°F and

80°F (16°- 27°C). DO NOT charge the battery pack in an air

temperature below +40°F (+4.5°C), or above +105°F (+40.5°C).

This is important and will prevent serious damage to the battery

pack.

2. The charger and battery pack may become warm to touch while

charging. This is a normal condition, and does not indicate a

problem. To facilitate the cooling of the battery pack after use, avoid

placing the charger or battery pack in a warm environment such as

in a metal shed, or an uninsulated trailer.

3. If the battery pack does not charge properly:

a. Check current at receptacle by plugging in a lamp or other

appliance

b. Check to see if receptacle is connected to a light switch

which turns power off when you turn out the lights.

c. Move charger and battery pack to a location where the

surrounding air temperature is approximately 60°F - 80°F

(16° - 27°C).

d. If charging problems persist, take the tool, battery pack and

charger to your local service center.

4. The battery pack should be recharged when it fails to produce

sufficient power on jobs which were easily done previously. DO NOT

CONTINUE to use under these conditions. Follow the charging

procedure. You may also charge a partially used pack whenever

you desire with no adverse affect on the battery pack.

5. Foreign materials of a conductive nature such as, but not limited

to, steel wool, aluminum foil, or any buildup of metallic particles

should be kept away from charger cavities. Always unplug the

charger from the power supply when there is no battery pack in the

cavity. Unplug charger before attempting to clean.

6. Do not freeze or immerse charger in water or any other liquid.

WARNING: Shock hazard. Do not allow any liquid to get

inside charger. Never attempt to open the battery pack for any

reason. If the plastic housing of the battery pack breaks or cracks,

return to a service center for recycling.

STATE OF CHARGE INDICATOR (FIGURE B)

The battery is equipped with a state of charge indicator. This can be

used to display the current level of charge in the battery during use

and during charging. It does not

indicate tool functionality and is subject

to variation based on product

components, temperature and end-

user application.

Checking state of charge during use:

• Press the state of charge indicator

button (B1).

• The four LEDʼs (B2) will illuminate

indicating the percent of charge in

the battery. See chart in figure B.

• If LED light does not

illuminate,charge battery.

INSTALLING AND REMOVING THE BATTERY PACK

WARNING: Make certain the lock-off button is engaged to

prevent switch actuation before removing or installing battery.

TO INSTALL BATTERY PACK:

Insert battery pack into tool until

fully seated and an audible click is

heard (figure C). Make sure

battery pack is fully seated and

fully latched into position.

TO REMOVE BATTERY PACK:

Depress the battery release button

in the back of the battery pack and

pull battery pack out of tool.

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LST136 Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Black & Decker LST136