Black & Decker GPC1800L Manuel d'utilisateur télécharger pdf (Page 9)

ENGLISH

(Original instructions)

Switching on and off (g. E)

For your safety, this tool is equipped with a double

switching system. This system prevents starting

the tool inadvertently.

Switching on

Push the lock-off button (2) backward using •

your thumb and at the same time squeeze the

on/off switch (1).

Release the lock-off button (2). •

Switching off

Release the on/off switch (1). •

Warning! Never attempt to lock a switch in the

on position.

Pruning (g. F)

Make sure the tool is running at full speed •

before making a cut.

Hold the tool rmly in place to avoid possible •

bouncing or sideways movement of the tool.

Guide the tool through the branch using light •

pressure. When cutting heavy branches, where

a partial cut may splinter and damage the tree,

proceed as follows:

Make the rst cut 15 cm from the tree trunk on -

the underside of the limb. Use the top of the

guide bar (7) to make this cut.

Cut one third through the diameter of the limb. -

Then cut down from the top.

Cleaning, maintenance and storage

Your Black & Decker corded/cordless appliance/

tool has been designed to operate over a long

period of time with a minimum of maintenance.

Continuous satisfactory operation depends upon

proper tool care and regular cleaning.

Warning! Before performing any maintencance

on corded/cordless power tools:

Switch off and unplug the appliance/tool•

Or switch off and remove the battery from •

the appliance/tool if the appliance/tool has a

separate battery pack

Or run the battery down completely if it is •

integral and then switch off

Unplug the charger before cleaning it. Your •

charger does not require any maintenance

apart from regular cleaning.

Regularly clean the ventilation slots in you appli-

ance/tool/charger using a soft brush or dry cloth.

After several charge and discharge cycles, the

battery will attain full capacity. The battery may

become warm while charging; this is normal and

does not indicate a problem.

Warning! Do not charge the battery at ambi-

ent temperatures below 10 °C or above 40 °C.

Recommended charging temperature: approx.

24°C.

Note: The charger will not charge a battery if

the cell temperature is below approximately 0

°C or above 60 °C.

The battery should be left in the charger and

the charger will begin to charge automatically

when the cell temperature warms up or cools

down.

To charge the battery (11), remove it from the

•

tool and insert it into the charger (12). The

battery will only t into the charger in one way.

Do not force. Be sure that the battery is fully

seated in the charger.

Plug in the charger and switch on at the mains. •

The charging indicator (24) will ash continuously

(slowly).

The charge is complete when the charging indica-

tor (9) lights continuously. The charger and the

battery can be left connected indenitely with the

LED illuminated. The LED will change to ashing

(charging) state as the charger occasionally tops

off the battery charge. The charging indicator (24)

will be lit as long as the battery is connected to the

plugged-in charger.

Charge discharged batteries within 1 week. •

Battery life will be greatly diminished if stored in

a discharged state.

•

Charging indicators

If the charger detects a problem with the battery,

the charging indicator (24) will ash at a fast rate.

Proceed as follows:

Re-insert the battery (11). •

If the charging indicators continues ashing at a •

fast rate, use a different battery to determine if

the charging process works properly.

If the replaced battery charges correctly, the •

original battery is defective and should be

returned to a service centre for recycling.

If the new battery gives the same indication •

as the original battery, take the charger to be

tested at an authorised services centre.

Note: It may take as long as 15 minutes to

determine that the battery is defective. If the

battery is too hot of too cold, the LED will al-

ternately blink fast and slow, one ash at each

speed and repeat.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Black & Decker GPC1800L Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker GPC1800L