Black & Decker CCS818 Manuel d'utilisateur télécharger pdf (Page 11)

• Rotate the tension adjustment screw (22) in the front of the housing

using the flat screwdriver end of the wrench (11) as shown in

figure F.

• Do not over-tension the chain as this will lead to excessive wear

and will reduce the life of the bar and chain. Overtensioning also

reduces the amount of cuts you will get per battery charge.

• Once chain tension is correct, tighten allen head screws (9).

• When the chain is new check the tension frequently (after

disconnecting battery) during the first 2 hours of use as a new chain

stretches slightly.

Chain Oiling

• A high quality bar and chain oil or

SAE30 weight motor oil should be

used for chain and bar lubrication. The

use of a vegetable based bar and chain

oil is recommended when pruning trees.

Mineral oil is not recommended

because it may harm trees. Never use

waste oil or very thick oil. These

may damage your chain saw.

• Lubricate the whole chain evenly

before each use as shown in

figure J. Also lubricate the chain

whenever replacing a fully

discharged battery with a fully

charged one.

Transporting Saw

• Always remove the battery (4)

from the tool (figure K) and cover

the guide bar (6) with the

scabbard (10) (figure L) when

transporting the saw. See the

warning under “Battery Cap

Information” for additional

information on transporting the

battery.

Operating the Chain Saw

WARNING: Read and understand all instructions. Failure to

follow all instructions listed below may result in electric shock, fire

and/or serious personal injury.

• Guard Against Kickback which can result in severe injury or

death. See Important Safety Instructions “Guard Against

Kickback”, to avoid the risk of kickback.

• Do not overreach. Do not cut above chest height. Make sure

your footing is firm. Keep feet apart. Divide your weight evenly on

both feet.

• Use a firm grip with your left hand on the front handle (15) and

your right hand on the rear handle (14) so that your body is to the

left of the guide bar.

• Do not hold chain saw by front hand guard (3). Keep elbow of left

arm locked so that left arm is straight to withstand a kickback.

WARNING: Never use a cross-handed grip (left hand on the

rear handle and right hand on the front handle).

WARNING: Never allow any part of your body to be in line

with the guide bar (6) when operating the chain saw.

• Never operate while in a tree, in any awkward position or on a

ladder or other unstable surface. You may lose control of saw

causing severe injury.

• Keep the chain saw running at full speed the entire time you

are cutting.

• Allow the chain to cut for you. Exert only light pressure. Do not

put pressure on chain saw at end of cut.

Connecting the Battery

• Place the battery (4) into the tool

as shown in figure M and be

certain that it is inserted fully into

the tool cavity until it “clicks” into

place. To remove the battery from

the tool, press down on the

release button (17) on the back of

the battery (figure C) and slide

out.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Black & Decker CCS818 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker CCS818