Toremoveanattachment,depressthereleasebutton(3)and
taketheattachmentoffthetool.
Tofitanattachment,lineitupwiththetootasshownandpush
itontothePowerUnituntilit snapsintoplaceandanaudible
clickisheard.
Ensureattachmentissecurelyattachedbygentlypullingit
awayfromthePowerUnit.
NOTE:Onlyuseattachmentsthatarespecificallydesigned
forandcompatiblewiththePowerUnit.
NOTE:Refertoindividualattachmentinstructionmanualsfor
specificsafetywarningsandoperatinginstructionsbeforeoper-
atingattachmentswiththePowerUnit.
OPERATING: DRILL/SCREWDRIVER ATTACHMENT
FITTING AND REMOVING A DRILL BIT OR SCREWDRIVER BIT
The drill/screwdriver attachment (5) is fitted with a keyless chuck (6) to allow for an easy exchange of bits.
Unplug the Power Unit before installing or removing attachments.
Open the chuck by turning the front part clockwise with one hand while holding the rear part
with the other.
Insert the bit shaft into the chuck.
Firmly tighten the chuck by turning the front part counterclockwise.
To remove the screwdriver bit from the holder, lift the bit from the recess.
To store the screwdriver bit, firmly push it into the holder (4).
SCREW DRIVING
Always use the correct type and size of screwdriver bit.
If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a lubricant.
Always hold the tool and screwdriver bit in a straight line with the screw.
For driving fasteners, the reversing button should be pushed to the left. Use reverse (button
pushed to the right) for removing fasteners. When moving from forward to reverse, or vice
versa, always release the trigger switch first.
KEYLESS CHUCK = FIGURE B
zLWARNING: Make certain the Power Unit is unplugged to
prevent switch actuation before installing or removing attachments.
ZLWARNING: Do not attempt to tighten or loosen drill bits (or
any other accessory) by gripping the front part of the chuck and
turning the tool on. Damage to the chuck and personal injury may
occur when changing accessories.
To insert a drill bit or other accessory:
1. Grasp the rear half of the chuck (6) with one hand and use
2,
your other hand to rotate the front half in the counterclockwise direction, as viewed from the
chuck end.
Insert the bit or other accessory fully into the chuck, and tighten securely by holding the rear half of
the chuck and rotating the front portion in the clockwise direction as viewed from the chuck end.
TORQUE CONTROL - FIGURE C
This toot is fitted with a torque adjustment collar (7) to select the t_.
operating mode and to set the torque for tightening screws. Large
screws and hard workpiece materials require a higher torque
setting than small screws and soft workpiece materials.
For drilling in wood, metal and plastics, set the collar to the
drilling position symbol B
For screwdriving, set the collar to the desired setting. If you do
not yet know the appropriate setting, proceed as follows:
Set the collar to the lowest torque setting.
Tighten the first screw.
If the clutch ratchets before the desired result is achieved, increase the collar setting and
continue tightening the screw. Repeat until you reach the correct setting. Use this setting
for the remaining screws.
6
(32 pages)
(64 pages)
(104 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels