Black & Decker Screwdriver BDCS80I Manuel d'utilisateur télécharger pdf (Page 6)

13. Do not charge or use battery in explosive atmospheres, such as in the presence of

flammable liquids, gases or dust. Inserting or removing the drill from the charger may

ignite the dust or fumes.

14. If battery contents come into contact with the skin, immediately wash area with mild

soap and water. If battery liquid gets into the eye, rinse water over the open eye for

three minutes or until irritation ceases. If medical attention is needed, the battery

electrolyte is composed of a mixture of liquid organic carbonates and lithium salts.

WARNING: Burn hazard. Battery liquid may be flammable if exposed to spark or flame.

CHARGING PROCEDURE

THE BATTERIES IN YOUR TOOL ARE NOT FULLY CHARGED AT THE FACTORY.

BEFORE ATTEMPTING TO CHARGE THEM, THOROUGHLY READ ALL OF THE

SAFETY INSTRUCTIONS.

To charge your tool, follow the steps below.

1. Plug the charger (7) into any standard 120 Volt 60 Hz

electrical outlet.

2. Insert the charger into the charging port (5), making

sure to line up the keyed plug with the port as shown

in figure A. The charging indicator LED (6) will flash,

indicating the battery inside the drill is being charged.

The completion of charge is indicated by the LED

remaining on continuously.

3. Let the tool charge initially for 9 hours. After the initial

charge, under normal usage, your tool should be fully

charged in 7 to 9 hours.

IMPORTANT CHARGING NOTES

1. After normal usage, your tool should be fully charged in 3 to 9 hours. Your tool was

sent from the factory in an uncharged condition. Before attempting to use it, it must

be charged for at least 9 hours.

2. DO NOT charge the batteries in an air temperature below 40°F (4,5° C) or above

105°F (40,5 °C). This is important and will prevent serious damage to the batteries.

Longest life and best performance can be obtained if batteries are charged when air

temperature is about 75°F (23,8° C).

3. While charging, the charger may hum and become warm to touch. This is a normal

condition and does not indicate a problem.

4. If the batteries do not charge properly—(1) Check current at receptacle by plugging

in a lamp or other appliance. (2) Check to see if receptacle is connected to a light

switch which turns power off when you turn out the lights. (3) Move charger and

tool to a surrounding air temperature of 40°F (4,5° C) to 105°F (40,5° C). (4) If the

receptacle and temperature are OK, and you do not get proper charging, take or

send the tool and charger to your local BLACK+DECKER service center. See Tools

Electric in yellow pages.

5. The tool should be recharged when it fails to produce sufficient power on jobs which

were easily done previously. DO NOT CONTINUE using product with its batteries in a

depleted condition.

OPERATING INSTRUCTIONS

QUICK RELEASE CHUCK (FIGURE B)

To install an accessory:

• Holdthetoolasshowninfigure B and push the chuck

collar away from the tool.

• Insertahexshankaccessoryandreleasethecollar.

• Theaccessoryislockedinplace.

NOTE: Use 2” bits or 1” bits with a bit tip holder (not

provided).

To remove an accessory:

• Holdthetoolasshowninfigure B and push the chuck

collar away from the tool.

• Removetheaccessoryandreleasethecollar.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Screwdriver BDCS80I Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Black & Decker Screwdriver BDCS80I