Black & Decker LPP120 Manuel d'instructions télécharger pdf (Page 12)

faraspossibleandrotatethesleeve

clockwiseuntilitstopsandcompletely

coverstheorangethreadsasshownin

figure16.

3.Repeatsteps1and2abovetoattach

thesawheadmoduletothecenter

extension.

Z_WARNING: Always check to make sure that the sleeve is

completely threaded on and that the orange threads are no

longer visible. Not threading the sleeve completely on could result

in the modules becoming disconnected creating a hazardous

condition. Periodically check the connections to insure that no

orange threads are visible.

Detaching Saw Head Module

Z_WARNING: Sharp moving blade. To prevent

accidental operation, insure that battery is

disconnected from the handle and that the

protective scabbard is in place on the chain

before performing the following operations.

Failure to do this could result in serious personal

injury.

When detaching the modules, whether it is in the two

module or three module mode, always detach the

saw head module first. To do this, rest the handle

module on the ground and grasp the center of the saw head module

with one hand figure 17. Use your other

hand to loosen the threaded sleeve figure

18 and then pull the two halves apart.

Repeat this process if the center extension

was attached.

_WARNING: Read and understand all instructions. Failure to

follow all instructions listed below may result in electric shock, fire

and/or serious personal injury.

Connecting the Battery

Place the battery in the tool as shown in figure

19 and be certain that it is inserted fully into the

tool cavity until it "clicks" into place. To remove

the battery from the toot, press down on the

release button on the back of the battery (figure

20) and slide out.

Switch

Always be sure of your footing and grip the

Pole Saw firmly with both hands with the

thumb and fingers encircling the handle.

To turn the tool ON pull the lock button (1)

back with your thumb and then squeeze

the trigger (2) with your fingers as shown

in figure 21. (Once the tool is running you

can release the lock button.) To turn the

tool OFF, release the trigger.

Auto-Stop Chain Braking System

Your chain saw is fitted with an auto-stop chain braking system which

will stop the chain quickly each time you release the rear trigger, or

if kickback should occur. This system should be tested before every

use.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LPP120 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker LPP120