Black & Decker LPP120 Manuel d'instructions Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 56
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Operating Position
Always Wear:
Head Protection
_'_k_ _),_-Eye Protection
_r'--.Work Gloves
Toed Shoes
Pole Saw Trimming /
runing
WARNINGS:
Never stand directly
limb you are
Always position
out of the path
debris.
Always wear head,
foot and body
_rotection. Wearing
)rotection helps
"educe the risk of injury
this unit.
Never stand on
ladder or other
)oft
using
the Pole
Always
position which
;an cause you to loose
_our balance and cause
revere injury.
Keep other persons at least 50 feet (15m) from the
work area. Distractions can cause you to lose control.
Electrocution Hazard. To prevent shock, do not
operate within 50 feet (15m) of overhead electrical
lines. Always check surrounding area for hidden
electrical lines.
Do not extend Pole Saw switch handle above
shoulder height.
Pruning With the Pole Saw
z_WARNING: When pruning trees:
Guard Against Kickback which can result
in severe injury or death. See "KICKBACK",
page 4 to avoid the risk of kickback.
Do not overreach. Make sure your footing is
firm. Keep feet apart. Divide your weight evenly
on both feet.
Use both hands to grip Pole Saw as shown
in figure 22. Use a firm grip. Thumbs and
fingers must wrap around Pole
Saw handle and pole. Keep fingers _'_=_
away from sawdust exhaust chute
shown in figure 22a.
Never operate while in a tree, in
any awkward position or on a
ladder or other unstable surface.
You may lose control of Pole Saw
causing severe injury.
Follow directions below to trim a tee.
1. Make sure Pole Saw is running at full speed before making a
cut. When starting a cut, place moving chain against limb. Hold
Pole Saw firmly in place to avoid possible bouncinq or skating
(sideways movement) of Pole _)
Saw.
2. Guide Pole Saw using light
pressure. Make first cut six inches
from tree trunk on underside of
limb. Use top of guide bar to make
this cut. Cut 1/3 through diameter v._<,_,,,<_
of limb. Then make the finish cut
from the top as shown in
figure 23. i(
13
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Commentaires sur ces manuels

Pas de commentaire