Black & Decker KS900SL Manuel d'instructions télécharger pdf (Page 8)

ENGLISH

tool is switched off and when it is running idle in addition to

the trigger time.

Labels on tools

Electrical safety

This tool is double insulated; therefore no earth

wire is required. Always check that the power

supply corresponds to the voltage on the rating

plate.

X This appliance is not intended for use by young or infirm

persons without supervision. Children must be

supervised to ensure they do not play with the

appliance.

X If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid a hazard.

Additional safety instructions for non-rechargeable

batteries

X Never attempt to open for any reason.

X Do not store in locations where the temperature may

exceed 40°C.

X When disposing of batteries, follow the instructions

given in the section "Protecting the environment".

Do not incinerate the batteries.

X Under extreme conditions, battery leakage may occur.

When you notice liquid on the batteries, proceed as

follows:

- Carefully wipe the liquid off using a cloth. Avoid skin

contact.

Additional safety instructions for lasers

X This laser complies with class 2 according to EN 60825-

1:. Do not replace a laser diode

with a different type. If the laser is damaged, have the laser

repaired by an authorised repair agent.

X Do not use the laser for any purpose other than projecting

laser lines.

X An exposure of the eye to the beam of a class 2 laser is

considered safe for a maximum of 0.25 seconds. Eyelid

reflexes will normally provide adequate protection. At

distances greater than 1m, the laser complies with class 1

and is therefore considered completely safe.

X Never look into the laser beam directly and intentionally.

X Do not use optical tools to view the laser beam.

X Do not set up the tool where the laser beam can cross any

person at head height.

X Do not let children come near the laser.

Features

1. Lock-on button

2. On/off switch

3. Blade storage compartment cover

4. Shoe plate locking lever

5. Dust extraction outlet

6. Dust extraction adaptor

7. Shoe plate

8. Auto Select

dial

9. Blade support roller

10. Tool-free blade clamp

Additional features (fig. A)

Additional features may be applicable depending upon the

product purchased. The additional features applicable to the

catalogue number purchased are shown in fig. A.

Assembly

Warning! Before attempting any of the following operations,

make sure that the tool is switched off and unplugged and that

the saw blade has stopped. Used saw blades may be hot.

Fitting the saw blade (fig. B)

X Hold the saw blade (11) as shown, with the teeth facing

forward.

X Push and hold the blade clamp (10) down.

X Insert the shank of the saw blade into the blade holder (12)

as far as it will go.

X Release the blade clamp (10).

Saw blade storage (fig. C)

Saw blades (11) can be stored in the storage compartment

located on the side of the tool.

X Open the cover (3) of the saw blade storage compartment

by holding the tab on the top of the cover (3) and pulling it

outward.

Warning! To reduce the risk of injury, the user must

read the instruction manual.

Read all of this manual carefully.

This product is not to be used by children

under 16.

Laser radiation.

Do not look into the laser beam.

Do not use optical tools to view the laser

beam.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Black & Decker KS900SL Manuel d'instructions Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker KS900SL