Black & Decker Drill DR260B Manuel d'utilisateur télécharger pdf (Page 9)

Drilling

• Alwaysunplugthedrillwhenattachingorremovingaccessories.Whenattaching

accessories in the drill chuck, it is important to securely tighten the chuck using all three

holes to prevent slippage. When using a keyless chuck, hand tighten firmly.

• Usesharpdrillbitsonly.

• Supportandsecureworkproperly,asinstructedinthesafetyinstructions.

• Useappropriateandrequiredsafetyequipment,asinstructedinthesafetyinstructions.

• Secureandmaintainworkarea,asinstructedinthesafetyinstructions.

• Plugindrill.Make sure switch turns drill on and off.

• Runthedrillveryslowly,usinglightpressure,untiltheholeisstartedenoughtokeepthe

drill bit from slipping out of it.

• Applypressureinastraightlinewiththebit.Useenoughpressuretokeepthebitbiting

but not so much as to stall the motor or deflect the bit.

• Hold the drill firmly with both hands to control its twisting action (figure A).

• Usesidehandleifdrill(DR560)isequippedwithone.

• DONOTCLICKTHETRIGGEROFASTALLEDDRILLOFFANDONINANATTEMPT

TO START IT. DAMAGE TO THE DRILL CAN RESULT.

• Minimizestallingonbreakthroughbyreducingpressureandslowlydrillingthroughthe

last part of the hole.

• Keepthemotorrunningwhilepullingthebitoutofadrilledhole.Thiswillhelpreducejamming.

Drilling In Wood

Holes in wood can be made with the same twist drill bits used for metal or with spade bits.

These bits should be sharp and should be pulled out frequently when drilling to clear chips

from the flutes.

Drilling In Metal

Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which

should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.

Troubleshooting

Problem Possible Cause Possible Solution

• Unitwillnotstart. •Cordnotpluggedin.  •Plugtoolintoaworking

outlet.

    •Forward/reverseslidernotfully •Pushslidercompletelyto

depressed in desired direction. the left or right.

    •Circuitfuseisblown.  •Replacecircuitfuse.

(If the product repeatedly

causes the circuit fuse to

blow, discontinue use

immediately and have it

serviced at a Black &

Decker service center or

authorized servicer.)

    •Circuitbreakeristripped.  •Resetcircuitbreaker.

(If the product repeatedly

causes the circuit breaker

to trip, discontinue use

immediately and have it

serviced at a Black &

Decker service center or

authorized servicer.)

    •Cordorswitchisdamaged. •Havecordorswitch

replaced at Black &

Decker Service Center or

Authorized Servicer.

For assistance with your product, visit our website www.blackanddecker.com for the

locationoftheservicecenternearestyouorcalltheBLACK&DECKERhelplineat

1-800-544-6986.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Drill DR260B Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker Drill DR260B