Black & Decker BT1000 Manuel d'instructions télécharger pdf (Page 11)

screw firmly with wrench provided. (Turn counterclockwise,

left-hand threads)

5. Return the guard bracket to its original position and firmly tighten

the guard bracket screw to hold bracket in place.

WARNING:

• The guard bracket must be returned to its original position and

the screw tightened before activating the saw.

• Failure to do so may allow the guard to contact the spinning

saw blade resulting in damage to the saw and severe personal

injury.

Assembling and Adjusting Your Saw

PERFORM ALL ASSEMBLY WITH SAW UNPLUGGED.

ATTACH MITER CLAMP HANDLE

Remove the miter clamp handle (4) from the plastic parts bag and

carefully thread it into the bracket in the front of the saw.

Adjustments

PERFORM ALL ADJUSTMENTS WITH THE MITER SAW

UNPLUGGED

NOTE: Your miter saw is fully and accurately adjusted at the factory

at the time of manufacture. If readjustment due to shipping and

handling or any other reason is required, follow the steps below to

adjust your saw.

MITER SCALE ADJUSTMENT

Place a square against the saw’s fence and blade, as shown in

Figure 6. (Do not touch the tips of the blade teeth with the square. To

do so will cause an inaccurate measurement.) Loosen the miter

clamp handle (4) as shown in Figure 7 and swing the miter arm until

the miter latch (5) locks it at the 0 miter position. Do not tighten the

clamp handle. If the saw blade is not exactly perpendicular to the

fence, loosen the two screws that hold the handle to the base (shown

in Figure 8) and move the arm of the saw left or right until the blade is

perpendicular to the fence, as measured with the square. Retighten

the two screws. Pay no attention to the reading of the miter pointer at

this point.

MITER POINTER ADJUSTMENT

Loosen the miter clamp handle (4) and squeeze the miter latch (5) to

move the miter arm to the zero position. With the miter clamp handle

loose allow the miter latch to snap into place as you rotate the miter

arm past zero. Observe the pointer and miter scale (6) through the

miter latch opening. If the pointer does not indicate exactly zero,

loosen screw and re-align the pointer.

GUARD ACTUATION AND VISIBILITY

The blade guard on your saw has been designed to automatically

raise when the arm is brought down and to lower over the blade when

the arm is raised.

The guard can be raised by hand when installing or removing saw

blades or for inspection of the saw. NEVER RAISE THE BLADE

GUARD MANUALLY UNLESS THE SAW IS TURNED OFF.

NOTE: Certain special cuts will require that you manually raise the

guard. To do this, simply place your right thumb on the upper side of

the guard and roll the guard up just enough to clear the workpiece.

Never tie up or otherwise prevent the guard from operating normally.

The front section of the guard is louvered for visibility while cutting.

Although the louvers dramatically reduce flying debris, they are

openings in the guard and safety glasses should be worn at all times

when viewing through the louvers.

If you have any questions, call 1-800-54-HOW-TO.

630669-00,BT1000 manual 2/15/05 8:11 AM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Black & Decker BT1000 Manuel d'instructions Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker BT1000