Black & Decker GH610 Manuel d'instructions télécharger pdf (Page 10)

• Wind the cutting line onto the spool in

the direction of the arrow on the spool.

Make sure to wind the line on neatly and

in layers. Do not crisscross (figure 16).

• When the wound cutting line reaches

the recesses (x), cut the line. (figure 15).

• Fit the spool onto the tool as described

in “REPLACING THE SPOOL”.

CAUTION: Before you begin

trimming, only use the appropriate type of

cutting line.

WARNING: To avoid serious injury, switch off and unplug the

tool before performing any maintenance.

1. Keep the air intake slots clean to avoid overheating.

2. Your trimmer line can dry out over time. To keep your line in top

condition, store spare pre-wound spools or bulk line in a plastic,

sealable bag with a tablespoon of water.

3. Plastic parts may be cleaned by using a mild soap and a damp

rag.

4. The line cutter on the edge of the guard can dull over time. It is

recommended you periodically touch-up the sharpness of the

blade with a file.

IMPORTANT: To assure product SAFETY and RELIABILITY,

repairs, maintenance and adjustment should be performed by

authorized service centers or other qualified service organizations,

always using identical replacement parts.

TOOL RUNS SLOWLY

• Check that the spool housing can rotate freely. Carefully clean it if

necessary.

• Check that the cutting line does not protrude more than

approximately 5-3/8 inches (136mm) from the spool. If it does, cut

it off so that it just reaches the line trimming blade.

AUTOMATIC LINE FEED DOES NOT WORK

• Keep the tabs depressed and remove the spool from the spool

housing in the trimmer head.

• Pull the cutting line until it protrudes approximately 5-3/8 inches

(136mm) from the spool. If insufficient cutting line is left on the

spool, install a new spool of cutting line.

• Ensure that the line is not crisscrossed on the spool as detailed

in figure 16. If it is, unwind the cutting line, then wind it back on

the spool neatly so that the lines do not cross.

• Align the tabs on the spool cap with the cut outs in the housing.

• Push the spool cap onto the housing until it snaps securely into

place.

• If the cutting line protrudes beyond the trimming blade, cut it off

so that it just reaches the blade. If the automatic line feed still

does not work or the spool is jammed, try the following

suggestions:

• Carefully clean the spool and housing.

• Remove the spool and check if the lever in the spool housing

can move freely.

• Remove the spool and unwind the cutting line, then wind it on

neatly again. Replace the spool into the housing.

TROUBLESHOOTING

MAINTENANCE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Black & Decker GH610 Manuel d'instructions Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Black & Decker GH610