Black & Decker Fire Storm FS200SD Manuel d'instructions télécharger pdf (Page 11)

ASSEMBLING STAND

1. Attach the rubber feet (H) Fig. 11 to the bottom of

each leg (F).

Locate the two legs (F) which have holes at the

bottom for attaching the wheel brackets (G) and

brace (E). (Make sure wheels and brackets are

properly oriented. See inset Figure 11.) To attach

the brackets, remove the nuts from the bolts and

insert the bolts through the holes in the bottom of the

two legs and into the holes in brace (E). Thread the

nuts back on the bolts and tighten. Assemble the

stand as shown in Fig. 11, using 16 M8x1.25x20mm

carriage head bolts, 3/8" flat washers and M8x1.25

hex nuts. Align the holes in the stand legs (F) with

the holes in the brackets. Insert the carriage head

bolt through the hole in the leg and the hole in the

bracket, place a flat washer on the carriage head bolt

and thread a hex nut onto the carriage head bolt.

Repeat this process for the 15 remaining holes in the

legs and brackets.

NOTE: Loosely tighten the hardware for further

adjustment.

Letters are on the stand brackets to ease assembly:

A - Top front and rear brackets

B - Top side brackets

C - Bottom side brackets

D - Bottom front and rear brackets

E - Bottom brace

NOTE: Each rubber foot is provided with holes for

mounting the stand to the floor surface if required.

Fig. 11

Fig. 13

SAW TO STAND

1. Turn saw table face down on a piece of cardboard to

protect the table surface. Place stand upside down

onto saw and align the four holes in the stand with

the mounting holes in the saw.

2. Place a 3/8" flat washer on a M8x1.25x45mm hex

head screw. Insert the hex head screw through the

mounting hole in the saw and the mounting hole in

the stand. Place another 3/8" flat washer on the hex

head screw and thread a M8x1.25 hex nut on the

screw and loosely tighten. Complete this process for

the other three holes.

3. Stand the saw upright, as shown in Fig. 13 (Saw is

shown fully assembled here).

4. Push down on top of the saw so that the legs of the

stand adjust to the surface of the floor. Tighten all

hardware securely.

ATTACHING THE BAG

1. Attach the dust bag to the bag frame and place the

frame of the dust bag inside the saw stand as shown

in Fig. 12. Refer to the section below to attach this

assembly to the saw.

Fig. 12

Wheel

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Black & Decker Fire Storm FS200SD Manuel d'instructions Page 11

Commentaires sur ces manuels