Black & Decker Fire Storm FS200SD Manuel d'instructions télécharger pdf (Page 18)

MITER GAUGE OPERATION

AND ADJUSTMENTS

For cross-cutting (blade set 90 degrees to the table), the

miter gauge can be used in either table slot. For bevel

cross-cutting (with the blade tilted), use the miter gauge

in the right table slot only so that the blade will be tilted

away from the miter gauge and your hands.

To operate the miter gauge, loosen the lock knob (E)

Fig. 37, and rotate the miter gauge to the desired angle.

Fig. 37

ADJUSTING BLADE PARALLEL TO MITER GAUGE SLOTS

The blade was adjusted parallel to the miter gauge slots at the factory. In order to ensure accurate cuts and help prevent

kickback, check this adjustment.

To adjust:

1. Raise the blade to its highest position and adjust the blade so that it is 90 degrees to the table.

2. Select a tooth on the saw blade that is set to the left. Mark this tooth with a pencil or marker.

3. Use a combination square (A) Fig. 38 against the miter gauge slot and adjust the blade (B) of the square until it

touches the marked tooth.

4. Rotate the blade and check the same marked blade tooth at the rear of the saw table (Fig. 39).

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 38

Fig. 39

Fig. 40

5. If the front and back measurements (Figs. 38 and 39)

are not identical, you can adjust the blade. Start by

loosening the nuts below the four screws (C) Fig. 40

on the table. Then loosen the screws (C). Carefully

move the saw blade until the blade is parallel to the

miter gauge slot. When done, tighten four nuts under

the table and the four screws (C) Fig. 40 securely.

NOTE: If sufficient adjustment cannot be achieved by

loosening the screws (C) Fig. 40, loosen the screw (D)

Fig. 40 necessary to make the adjustment.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Pas de commentaire

Black & Decker Fire Storm FS200SD Manuel d'instructions Page 18