Black & Decker Fire Storm FS200SD Manuel d'instructions télécharger pdf (Page 16)

Fig. 32

BLADE TILT ADJUSTMENT

To tilt the saw blade, loosen the lock handle (A)

Fig. 32 and move the handwheel (B) until the blade is at

the desired angle. Tighten the lock handle (A).

NOTE: The lock handle (A) is spring-loaded. Pull out on

the handle (A) and reposition it on the serrated stud

located underneath the handle.

THE BLADE TILTING LOCK HANDLE

(A) MUST BE LOCKED DURING ALL

CUTTING OPERATIONS.

TO ADJUST POSITIVE STOP AT 90 DEGREES

1. Raise the saw blade to its maximum height.

2. Loosen the blade tilting lock handle (A) Fig. 32, move

the blade tilting mechanism (B) as far as possible to

the left, and tighten the blade tilting lock handle (A).

3. Place a square (A) Fig. 33 on the table with one end

of the square against the blade, and check to see if

the blade is 90 degrees to the table. If not, loosen the

screw (B) Fig. 33 a few turns and move the blade

tilting mechanism until the blade is 90 degrees to the

table. Tighten the blade tilting lock handle (A) Fig. 32,

and tighten the screw (B) Fig. 33 until it stops.

Fig. 33

DISCONNECT MACHINE FROM POWER SOURCE.

90 AND 45 DEGREE POSITIVE STOP ADJUSTMENTS

Your saw is equipped with positive stops for rapid and accurate positioning of the saw blade at 90 and 45 degrees to

the table.

Fig. 34

TO ADJUST POSITIVE STOP AT 45 DEGREES

1. Raise the saw blade to its maximum height.

2. Loosen the blade tilting lock handle (A) Fig. 32, move

the blade tilting mechanism (B) as far as possible to

the right, and tighten the blade tilting lock handle (A).

3. Place a square (A) Fig. 34 on the table with one end

of the square against the blade, and see if the blade

is 45 degrees to the table. If not, loosen the screw

mechanism (B) Fig. 32, until the blade is 45 degrees

to the table. Tighten the blade tilting lock handle (A)

Fig. 32, and tighten the screw (C) Fig. 34 until it

stops.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Pas de commentaire

Black & Decker Fire Storm FS200SD Manuel d'instructions Page 16