Black & Decker Fire Storm FS200SD Manuel d'instructions télécharger pdf (Page 24)

Fig. 54

Fig. 55

Kerf should be about 1/4" apart.

Fig. 54, illustrates dimensions for making a typical featherboard. The material which the featherboard is constructed

of, should be a straight piece of wood that is free of knots and cracks. Featherboards are used to keep the work in

contact with the fence and table, as shown in Fig. 55, and help prevent kickbacks. Clamp the featherboards to the

fence and table so that the leading edge of the featherboards will support the workpiece until the cut is completed. An

8 inch high flat board can be clamped to the rip fence and the featherboard can be clamped to the 8 inch high board.

Use featherboards for all non “thru-sawing” operations where the guard and splitter assembly

must be removed. Always replace the guard and splitter assembly when the non thru-sawing operation is

completed.

CONSTRUCTING A FEATHERBOARD

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Pas de commentaire

Black & Decker Fire Storm FS200SD Manuel d'instructions Page 24