Black & Decker MM850 Manuel d'instructions télécharger pdf (Page 5)

Attaching

Extension Cord

To Mower

DO NOT connect the extension cord to

power source until you have finished

reading this manual and you are ready to

start mowing.

STEP 1-Read the

Polarized plug section on page 4

before plugging the extension cord into

the switch housing as shown in figure

1. The extension cord must be

polarized and will only plug in one way,

orient the wide slot with the wide blade

in the switch housing.

STEP 2-Loop the extension cord and

push the loop up through the hole in

the switch housing.

STEP 3-Pull the extension cord on the

side of the loop that is plugged into the

switch housing and remove all the

slack in this section of the extension

cord.

STEP 4-Place the loop over the strain

relief tab on the switch housing and pull

the extension cord so the loop draws

down around the strain relief tab as

shown in the detail. Double check to

see that you did not loosen the

extension cord in step 3.

Unpacking

Your mulching mower has been

completely assembled at the factory

except for the Grassbag.

CAUTION: Do not lift the lawnmower off

the ground by holding the

finger grip. See Figure 4.

To remove mulching mower from

carton

1. Remove the Grassbag frame,

Grassbag assembly instructions, and

cardboard fillers.

2. Remove the mower from the carton

and place all four wheels on the

ground or floor. See Figure 2.

3. Check the carton thoroughly and make

sure there are no loose parts.

To Unfold Handle

Raise the handle section into place and

secure by tightening the two knobs. See

Figure 2 and 3.

WARNING: For your own safety DO NOT

use this mower without either

the Grasscatcher or Mulch

Insert in operating position.

To Assemble

Grassbag

To assemble the Grassbag to the

Grassbag frame, read the instructions

supplied with the Lawnmower.

Wheel Height Adjustment

(from 1-14” to 3-1/2”)

1. Before making any adjustments, turn

off, unplug mower and wait for blade to

stop.

2. Your mulcher features the Black &

Decker one touch wheel height

adjustment system. This system will

adjust all four wheels at the same

time.

3. To raise or lower the cutting height.

See Figure 4. Rest the palm of your

hand on the palm rest and with your

5

ENGLISH

MINIMUM GAUGE FOR CORD SETS

120 VOLTS Required Cord Length

Cord Length in Feet

25 50 100 150

Wire Gauge

12-16 14 12

If you have any questions call the Consumer 1-800 Help Line as listed in this instruction manual.

MOTOR

AMP

RATING

NOT RECOMMENDED

FINGER

GRIP

PALM

REST

FIG. 4

POINTER

SCALE

STRAIN

RELIEF

TAB

1 2 3 4 5 6 7 8 9 10 ... 34 35

Commentaires sur ces manuels

Pas de commentaire