Black & Decker HC2000 Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

1. To assemble, place the unit on

a counter or other flat work sur-

face. Place the Bowl onto the

Base, lining up the Bowl Locking

Tabs to the Locking Slots.

2. Turn clockwise until the Bowl

locks. (Figure A)

3. Slide the Knife Blade down over

the shaft. Be careful not to touch

the Blade as it is extremely sharp.

4. Place the Cover on the Bowl,

with the Extended Tab on the

same side as the Base Slot. Turn

the Cover clockwise into the Base

Slot as far as it will go. The Cover

Handle will line up with the

Pulse/On Switch. (Figure B)

NOTE: For your protection, this

unit has a Cover Interlock

System. The unit will not operate

unless the Extended Tab is cor-

rectly located inside the Base

Slot. Do not attempt to operate

the unit without the Cover being

correctly placed.

ASSEMBLING THE UNIT

1. To use, remove the Cover and place up to 1 cup of dry foodin the

bowl. (See “Guide To Use.”

2. Place the Cover on the Bowl and turnto lock into place.

3. Depress and hold the Pulse/On Button to proces.

NOTE: The longer the continuous pulse, the finer the texture. For

coarsely chopped foods, use short pulses.

4. If the Chopper does not operate, be sure the Bowl Locking Tabs are

properly positioned, and the Cover properly aligned. The parts are

designed to “lock” into position.

5. Be sure the Blade stops turning completely before removing the

Cover. Unplug the unit. remove the cover and grasp the plastic blade

hub. Carefully pull the Knife Blade straight up. Remove the Bowl and

empty the processed food. Do not use Bowl for storing food.

CHOPPING / MINCING

1 2 3 4 5 6

Pas de commentaire

Black & Decker HC2000 Manuel d'utilisation et d'entretien Page 4