Black & Decker FX1200 Spécifications télécharger pdf (Page 42)

4242

MA Lighting Technology GmbH

Dachdeckerstr. 16

D-97297 Waldbüttelbrunn

www.malighting.de eMail: [email protected]

2.132.13

2.13

Settings in the Setup MenuSettings in the Setup Menu

Settings in the Setup Menu

1 By shortly pressing this button, you can set the confirmation menus (e.g. SAVE) to be displayed on either only the

right-side TFT touchscreen or on all displays.

2 By clicking this button, four calibrating buttons, numbered 1 to 4, will be displayed on the respective TFT display.

Now, activate the buttons using your finger or the supplied pen (special pen with soft rubber core). After the last

button, the display will automatically switch back. Now, the touchscreen is calibrated. The setting will automatically

be saved.

3 With the respective button, the touch screens can be switched on or off, respectively. If one of them is faulty, it may

occur that the mouse will freeze on one position and can not be operated anymore. In this case, the touchscreens

can be switched off. For this, use function key F9 on the keyboard.

F9 will switch off all three touchscreens (emergency switch). To switch the touchscreensF9 will switch off all three touchscreens (emergency switch). To switch the touchscreens

F9 will switch off all three touchscreens (emergency switch). To switch the touchscreens

back on, you can use the mouse again.back on, you can use the mouse again.

back on, you can use the mouse again.

4 To switch the mouse function on both external monitors on and off. In AUTO mode, the software will recognize by

itself, if a monitor is connected or not and will switch the mouse function for the external monitors on or off,

respectively.

OFF

will not allowwill not allow

will not allow any mouse function, while ON will keep the mouse function

activatedactivated

activated at all times.

5 With this button, the grandMAs acoustic sensor can be switched on or off (with older grandmas, probably not

available).

6 To set the sensitivity of trackball and coarse, fine or extra fine (16bit resolution) of the Encoder. With the PUSH

button, you can set the Encoders sensitivity while holding the button down.

7 Switching between the Motorfader functions (Executor Fader, Channel Fader).

AUTO: Executor Faders: When switching between the Pages, the Motorfaders will automatically pick up

the values saved last.

Channel Faders: Faders adjust to the called-up values of the allocated channels.

MANUAL: Executor Faders: When switching between the Pages, the saved values will be called up, but the

Faders will

t t

t follow. To change a saved value, you have to use the Fader to

manually set it to a higher or lower value.

Channel Faders: Faders do not adjust automatically to the called-up values of the assigned channels.

To change a saved value, you have to use the Fader to manually set it to a higher

or lower value.

2.13 Settings in the Setup Menu

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 204 205

Commentaires sur ces manuels

Pas de commentaire

Black & Decker FX1200 Spécifications Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Transformateurs de denrées alimentaires Black & Decker FX1200