Black & Decker GTC800NM Manuel d'instructions télécharger pdf (Page 7)

100

ENGLISH

Safety of others

u This appliance is not intended for use by persons

(including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction

concerning use of the appliance by a person responsible

for their safety.

u Children should be supervised to ensure that they do not

play with the appliance.

Residual risks.

Additional residual risks may arise when using the tool which

may not be included in the enclosed safety warnings. These

risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations

and the implementation of safety devices, certain residual

risks can not be avoided. These include:

u Injuries caused by touching any rotating/moving

parts.

u Injuries caused when changing any parts, blades or

accessories.

u Injuries caused by prolonged use of a tool. When

using any tool for prolonged periods ensure you take

regular breaks.

u Impairment of hearing.

u Health hazards caused by breathing dust developed

when using your tool (example:- working with wood,

especially oak, beech and MDF.)

Vibration

The declared vibration emission values stated in the technical

data and the declaration of conformity have been measured in

accordance with a standard test method provided by

EN 60745 and may be used for comparing one tool with

another. The declared vibration emission value may also be

used in a preliminary assessment of exposure.

Warning! The vibration emission value during actual use of

the power tool can differ from the declared value depending

on the ways in which the tool is used. The vibration level may

increase above the level stated.

When assessing vibration exposure to determine safety

measures required by 2002/44/EC to protect persons regularly

using power tools in employment, an estimation of vibration

exposure should consider, the actual conditions of use and the

way the tool is used, including taking account of all parts of the

operating cycle such as the times when the tool is switched off

and when it is running idle in addition to the trigger time.

Warning symbols

The following warning symbols are found on the tool:

Warning! To reduce the risk of injury, the user must

read the instruction manual.

Do not use the tool in wet conditions or expose it to

rain.

Wear safety glasses or goggles when operating this

tool.

Do not incinerate the battery.

Beware of falling objects. Keep bystanders away.

Electrocution hazard. Keep at least 10 m away from

overhead lines.

Additional safety instructions for batteries and

chargers

Batteries

u Never attempt to open for any reason.

u Do not expose the battery to water.

u Do not expose the battery to heat.

u Do not store in locations where the temperature may

exceed 40 °C.

u Charge only at ambient temperatures between 10 °C and

40 °C.

u Charge only using the charger provided with the tool.

u When disposing of batteries, follow the instructions given

in the section "Protecting the environment".

u Do not damage or deform the battery either by puncture or

impact, as this can create a risk of injury and re.

u Do not charge damaged batteries.

Chargers

Warning! Your charger has been designed for a specic

voltage. Always check that the mains voltage corresponds to

the voltage on the rating plate.

u Use your Black & Decker charger only to charge the

battery in the tool with which it was supplied. Other

batteries could burst, causing personal injury and damage.

u Never attempt to charge non-rechargeable batteries.

u If the supply cord is damaged, it must be replaced by the

manufacturer or an authorised Black & Decker Service

Centre in order to avoid hazard.

1 2 3 4 5 6 7 8 9 10 11 12 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Black & Decker GTC800NM Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Taille-haie électrique Black & Decker GTC800NM