Black & Decker CST1200 Manuel d'instructions télécharger pdf (Page 6)

LED INDICATOR LIGHT

The unit is equipped with a red LED charging indicator light, located

on the upper left side of the unit (Figure 1). The indicator light will

come on when the unit is properly connected to the charging base

and the power plug is inserted into the electrical outlet. The light will

remain on, so long as the unit is properly connected to the powered

charging base. It is recommended to store the unit on the charger

during the growing season, with the charger plugged in, to have the

battery charged for the next use.

TO CHARGE YOUR BATTERY, FOLLOW THE STEPS BELOW

1. Install the trimmer onto the charger bracket by positioning the

handle cavity, shown in Figure 4 over the hook of the charger

bracket.

2. Rotate the trimmer down, keeping the hook engaged with the

handle cavity, and position the charge port over the bracketʼs

charge pin (Figure 4).

3. Plug the charger into any standard 120 volt, 60Hz outlet.

Charging will be automatically controlled until you remove the

trimmer from the bracket.

4. It is recommended that the trimmer be left on charge, during the

growing season. For winter or other extended periods of

storage, it is recommended that the unit be fully charged prior to

storage.

OPERATION INSTRUCTIONS

CAUTION: ALWAYS WEAR EYE PROTECTION.

CAUTION: Inspect area to be trimmed and remove any wire,

cord, or string-like objects which could become entangled in the

rotating line or spool. Be particularly careful to avoid any wire which

might be bent outwardly into the path of the tool, such as barbs at the

base of a chain link fence.

MOUNTING THE CHARGER BRACKET (FIGURE 4)

1. If you intend to mount the

charger bracket on a wall,

follow the instructions

listed below.

2. Use the hardware

provided (Figure 1D) only

if hanging on conventional

hollow wall construction

such as drywall over studs.

If not, use the appropriate

fasteners for the particular

wall material.

3. Use the charger bracket

to mark the locations of

the holes required. Be

sure to mount the bracket

high enough so that the

trimmer can hang freely

from it; about 4 feet (1.2m)

from the floor and close

enough to an electrical

outlet to plug-in charging

transformer.

4. a) Conventional hollow wall: Drill a .250 in. (6mm) diameter

hole at each marked location. Insert the plastic anchors supplied

into the holes and insert one of the screws into each anchor.

4. b) Alternative wall materials: Insert fasteners as appropriate

making sure screw heads are small enough to fit through bracket.

5. Tighten the screws until the heads are above the wall just

enough so that the charger bracket will fit between the wall and

the screw head.

6. Place the charger bracket on the wall (hook end up) and make

sure that the power cord is positioned in the side slot. Press the

charger bracket over the screw heads and slide it down until it

sits firmly on the screws.

7. Firmly tighten both screws.

Charging port and pin

Orifice de chargement et

tige

Puerto y punta de carga

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Black & Decker CST1200 Manuel d'instructions Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Black & Decker CST1200