Black & Decker 90504614 Manuel d'instructions télécharger pdf (Page 7)

3. While charging, the charger may hum and become warm to touch. This is a normal

condition and does not indicate a problem.

4. If the batteries do not charge properly—(1) Check current at receptacle by plugging

in a lamp or other appliance. (2) Check to see if receptacle is connected to a light

switch which turns power off when you turn out the lights. (3) Move charger and tool

to a surrounding air temperature of 40°F (4,5 °C) to 105°F (+40,5 °C). (4) If the

receptacle and temperature are OK, and you do not get proper charging, take or

send the tool and charger to your local Black & Decker service center. See Tools

Electric in yellow pages.

5. The tool should be recharged when it fails to produce sufficient power on jobs

which were easily done previously. DO NOT CONTINUE using product with its

batteries in a depleted condition.

Operating Instructions

Trigger Switch & Forward/Reverse Button - Figure B

• The drill is turned ON and OFF by pulling and releasing the trigger switch (3).

• The farther the trigger is depressed, the higher the speed

of the drill.

• A forward / reverse control button (4) determines the

direction of the tool and also serves as a lock off button.

• To select forward rotation, release the trigger switch and

depress the forward / reverse control button to the left.

• To select reverse, depress the forward / reverse control

button the opposite direction.

• The center position of the control button locks the tool in

the off position. When changing the position of the control

button, be sure the trigger is released.

NOTE: Under heavy loads the drill may cut out as a safety precaution. If this

happens, release the trigger switch and squeeze it again to start the drill.

Torque Control - Figure C

This tool is fitted with a collar to select the operating mode

and to set the torque for tightening screws. Large screws

and hard workpiece materials require a higher torque

setting than small screws and soft workpiece materials.

• For drilling in wood, metal and plastics, set the

adjustable torque collar (2) to the drilling position symbol

• For screwdriving, set the adjustable torque collar (2) to

the desired setting. If you do not yet know the

appropriate setting, proceed as follows:

• Set the collar to the lowest torque setting.

• Tighten the first screw.

• If the clutch ratchets before the desired result is achieved, increase the collar setting

and continue tightening the screw. Repeat until you reach the correct setting. Use

this setting for the remaining screws.

Dual Range Gearing - Figure D

The dual range feature (5) of your drill allows you to shift

gears for greater versatility.

• To select low speed, high torque setting (position 1), turn

tool off and permit to stop. Slide gear shifter button (5)

away from the chuck.

• To select the high speed, low torque setting (position 2),

turn tool off and permit to stop. Slide gear shifter button

towards the chuck.

NOTE: Do not change gears when tool is running. If you are

having trouble changing gears, make sure that the dual

range gear button is either completely pushed forward or completely pushed back.

90504614 SC1400 Lith Ion drill 6/19/06 9:49 AM Page 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Black & Decker 90504614 Manuel d'instructions Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Black & Decker 90504614