Black & Decker RC865 Manuel d'instructions télécharger pdf (Page 54)

Advanced Operations

En-54

Operating

procedure

(➔ page 44)

■ InstaPrevue

These settings apply to “InstaPrevue” of the Home

(➔ page 40) and specify the preview display of

HDMI video streams.

Sub Window

` Multi

Displays preview thumbnails all at once.

` Single:

Displays preview thumbnails one-by-one.

With this setting, you can set the number of preview

thumbnails displayed.

Position

(with “Sub Window” set to “Multi”)

` Top, Bottom

, Left, Right

(with “Sub Window” set to “Single”)

` UpperL, UpperR, LowerL, LowerR

With this setting, you can set the position of preview

thumbnails on the TV screen.

Note

• Depending on video signals, the picture may not be

properly rendered on the preview thumbnails of

InstaPrevue.

This section explains how to configure the AV

receiver’s network settings manually.

After modifying the network settings, you must

confirm the changes by executing “Save”.

If your router’s DHCP server is enabled, you don’t

need to change any of these settings, as the AV

receiver is set to use DHCP to configure itself

automatically by default (i.e., DHCP is set to

“Enable”). If, however, your router’s DHCP server is

disabled (you’re for example using static IP), you’ll

need to configure these settings yourself, in which

case, a knowledge of Ethernet networking is

essential.

What’s DHCP?

DHCP (Dynamic Host Configuration Protocol) is used

by routers, computers, the AV receiver, and other

devices to automatically configure themselves on a

network.

What’s DNS?

The DNS (Domain Name System) translates domain

names into IP addresses. For example, when you

enter a domain name such as www.onkyousa.com in

your Web browser, before accessing the site, your

browser uses DNS to translate this into an IP

address, in this case 63.148.251.142.

■ MAC Address

This is the AV receiver’s MAC (Media Access

Control) address. This address cannot be changed.

■ DHCP

` Enable

` Disable

This setting determines whether or not the AV

receiver uses DHCP to automatically configure its IP

Address, Subnet Mask, Gateway, and DNS Server

settings.

Note

• If you select “Disable”, you must configure the “IP

Address”, “Subnet Mask”, “Gateway”, and “DNS Server”

settings yourself.

■ IP Address

` Class A:

“10.0.0.0” to “10.255.255.255”

` Class B:

“172.16.0.0” to “172.31.255.255”

` Class C:

“192.168.0.0” to “192.168.255.255”

Enter a static IP address provided by your Internet

Service Provider (ISP).

Most routers use Class C IP addresses.

■ Subnet Mask

Enter the subnet mask address provided by your ISP

(typically 255.255.255.0).

■ Gateway

Enter the gateway address provided by your ISP.

■ DNS Server

Enter the DNS server address provided by your ISP.

■ Proxy URL

To use a Web proxy, enter its URL here.

■ Proxy Port

If you’re using a Web proxy, enter a proxy port

number here.

11. Network Setup

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 119 120

Commentaires sur ces manuels

Pas de commentaire

Black & Decker RC865 Manuel d'instructions Page 54

Commentaires sur ces manuels