Black & Decker BDSA100 Manuel d'instructions télécharger pdf (Page 8)

Attach the belt and pulley guard (A) Fig. 4 to the

machine base using the two M6x1x30mm cheese head

screws (B).

1. Turn the 1/4-20 x 1/4 in. hex socket set screw (A)

Fig. 5 counter-clockwise until it clears the hole (B)

in the sanding plate.

ATTACHING THE BELT AND PULLEY GUARD

Fig. 4

INSTALLING THE SANDING DISC PLATE

Fig. 5

ADJUSTING THE BELT TENSION

Your sander was shipped from the factory with the drive belt (A) Fig. 1 attached to both pulleys (B) and (C). Before

assembling the machine, check and adjust the belt tension.

1. Loosen the screw (D) Fig. 1 with the 6mm hex wrench, and move the sanding arm (E) to the vertical position to

expose belt tensioning screw (F) Fig. 2, and locknut (G).

Fig. 1

Fig. 2

2. Check the belt tension by applying light pressure on

the belt halfway between the two pulleys.The belt

has the correct tension when you can deflect it

approximately 1/4 in.

NOTE: The belt does not require excessive tension to

function properly.

3. To adjust, loosen the locknut (A) Fig. 3, and tighten

or loosen the adjusting screw (B) with the supplied

6mm hex wrench until the belt has the correct

tension.

4. Tighten locknut (A).

5. Move the sanding arm to the horizontal position.

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Pas de commentaire

Black & Decker BDSA100 Manuel d'instructions Page 8