Black & Decker TL10 Manuel d'instructions télécharger pdf (Page 8)

OPERATING INSTRUCTIONS

BALLAST TANK - (FIGURE H)

To improve the tilling performance, ballast (extra weight), can be added to

the tiller with the provided ballast tank.

1. Fill the ballast tank with dry sand only. Open the door (H-1) of the tank

and pour in the fill material to the MAX line on the tank.

ATTACHING EXTENSION CORD TO TILLER - (FIGURE I)

DO NOT connect the extension cord to power source until you have finished reading this manual and you are ready to

start operation.

DANGER: Avoid accidental starting. Make sure you are in the

operating position behind the tiller when using it. To avoid serious injury,

the operator and unit should be in a stable position while starting.

1. The extension cord must be polarized and will only plug in one way, by

orienting the wide slot with the wide blade in the switch housing.

2. Loop the extension cord (I-1) and push the loop up through the hole in

the switch housing.

3. Pull the extension cord on the side of the loop that is plugged into the

switch housing and remove all the slack in this section of the extension

cord.

4. Place the loop over the strain relief tab (I-2) on the switch housing

and pull the extension cord so the loop draws down around the strain

relief tab as shown in the detail. Double check to see that you did not

loosen the extension cord.

5. Plug the extension cord into a 120 volt, 60 cycle AC grounded outlet.

The tiller will operate satisfactorily on a

circuit with a 15 ampere breaker.

Note: To avoid tripping circuit breakers, select an outlet on a circuit that is not overloaded. Do not select an outlet

that is on a circuit with other appliances such as a refrigerator.

ON-OFF SWITCH - FIGURE J

1. Stand behind the tiller and grasp the upper handle.

2. Pivot the tiller slightly toward the rear, so that its weight is resting on its wheels and the tines are not in contact with

the ground.

Note: Starting the tiller motor also starts the tilling action.

3. To operate the switch, insert your finger into the opening (J-1) and

push the lever (J-2) out so that you can grasp it with your other hand.

4. Pull the lever back to turn the unit on and hold it against the tiller han-

dle to keep it running.

5. To turn the tiller off, release the lever. The spring loaded "SNAP AC-

TION" lever will quickly turn the tiller off.

DANGER: NEVER ATTEMPT TO OVERRIDE THE OPERATION OF

THIS SWITCH.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Pas de commentaire

Black & Decker TL10 Manuel d'instructions Page 8