JXG4604A
Owner’s Manual
15
burner tube can lead to
a fire beneath the appliance.
2.
All valves must be in the “OFF” position.
3.
Open cylinder valve.
4.
Ignite only the burners
you
wish to use, using the same method for each:
Push desired burner valve knob and rotate slowly about 1/4 counterclockwise until a click is heard.
The burner should light. If the burner does not light, return the valve knob to the “OFF” position immediately.
Wait five minutes for the gas
to clear and repeat the procedure. After burner is lit, repeat the procedure with any other burner desired.
5. Adjust valve knob(s) to desired cooking temperature.
Using the Lighting Stick to Light the
Main Burners
1.
Insert a match into
the end of lighting stick locked in the drawer. Light the match.
2.
Once lit, put the lighting stick through
the cooking grid and place the flame next to
the burner ports found along the sides of the desired burner (See diagram to right.)
3. Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’
position. The burner should light immediately.
If more than
one burner
is desired, repeat the procedure 2-3
until all desired burners are lit
.
4.
Adjust burners to the desired cooking temperature.
Precautions
1.
After lighting, observe the
burner flame.
Make sure all burner ports are lit.
2.
If the burner flame goes out during operation, immediately turn
the gas “OFF”.
Open
lid to let the gas clear for at least
5 minutes before re-lighting.
3.
Before
cooking on the grill for the first time and operate the
grill for approximately 15
minutes
with the lid closed and the gas
turned on “HIGH”.
This
will
“heat clean” the internal parts, dissipate odor from the manufacturing process and painted finish.
4.
Clean the grill after each use. DO NOT
use
abrasive or flammable cleaners. This may damage parts of the grill and cause a
fire.
Side Burner
1. Open lid
while lighting the burner. Lid must remain open
while burner is lit.
2. Valve
must be in the “OFF” position.
3. Open cylinder valve.
4
.
Push side burner knob fully and rotate it slowly about 1/4 turn counterclockwise until a click is heard. The burner should light.
If the burner does not light, turn the knob to the “OFF” position immediately. Wait five minutes for the gas to clear and repeat
the procedure.
5. Adjust valve knob to the desired cooking temperature
Using the Lighting Stick to Light the
Side
Burner
1. Open lid
while lighting the burner. Lid must remain open
while burner is lit
2. Remove the lighting stick then insert a match into
the end of lighting stick.
Light the match.
3. Once lit, place the flame to reach the
burner ports. (See diagram to right.)
4. Press the control knob and rotate it counterclockwise to the ‘’HIGH’’
position. The burner should light immediately.
5.
Adjust burner to the desired cooking temperature.
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A,B
and C below for the proper flame patterns). If the flame pattern is other than normal, consult
the Troubleshooting on page 18 for corrective action.
Observe flame
height
when lit:
Flame
should
be a blue/yellow
color between 1 to 2 inches
high.
2 in.
1 in.
0 in.
(32 pages)
(8 pages)
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels