Black & Decker black&decker fsmh1621 Manuel d'utilisateur télécharger pdf (Page 8)

ENGLISH

(Original instructions)

Hints for optimum use

General

Caution! Never use the steam mop without rst attaching a

cleaning pad.

u During steam mop use you can use the cable manage-

ment clip (17) to keep your cable out of the way of the

work area..

u Always vacuum or sweep the oor before using the steam

mop.

u The easiest way to use the machine is to tilt the handle to

a 45˚ angle and clean slowly, covering a small area at a

time.

u Do not use chemical cleaners with your steam mop. To

remove stubborn stains from vinyl or linoleum oors, you

can use the steam burst button to apply extra steam to

the area or pre-treat with a mild detergent and some water

before using the steam mop.

Steam cleaning with the mop

u Fit hand held steam cleaner (5) to the steam mop body

(9).

u Place a cleaning pad (12) on the oor with the ‘hook &

loop’ side facing up.

u Raise the steam mop off the resting mat (13) and lightly

press it down onto the cleaning pad (12).

u Place the steam mop on the resting mat.

u Connect the steam mop to the mains.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Press the Autoselect

button (6) till the required setting is

reached.

u Pulling the handle (10) back will activate the steam pump.

After a few seconds steam will start to come out of the

steam head.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

u It takes a few seconds for steam to enter the cleaning pad.

The steam mop will now glide easily over the surface to be

sanitised/cleaned.

u Push and pull the steam mop slowly across the oor to

thoroughly steam clean each section.

Note: During use you may turn off the steam pump by return-

ing the handle to the upright position, this convenient feature

will allow you to place the steam mop on the resting mat for

a short time so that you may move items of furniture, then

continue cleaning without the need to switch the appliance off.

u When you have nished using the steam mop, return the

handle (10) to the upright position and turn it ‘OFF’, place

it on the resting mat (13) and wait until the steam mop

cools down. (approximately ve minutes)

Caution! It is important to monitor the water level in the water

tank. To rell the water tank and continue to sanitise/clean, re-

turn the handle (10) to the upright position and turn the steam

mop ‘OFF’. Unplug the unit from the electrical wall outlet, rell

the water tank (8).

Caution! Never leave the steam mop in one spot on any

surface for any period of time. Always place the steam mop on

the resting mat (13) with the handle (10) in the upright position

when stationary and make sure the steam mop is turned off

when not in use.

Carpet refreshing

u Place a cleaning pad (12) on the oor with the ‘hook &

loop’ side facing up.

u Raise the steam mop off the resting mat (13) and lightly

press it down onto the cleaning pad (12).

u Place the carpet glider (14) on the oor.

u Lightly press the steam mop down onto the carpet glider

(14) until it clicks into place.

u Place the steam mop on the resting mat. (13)

u Connect the steam mop to the mains.

u Press the ON/OFF button (1). It takes approximately 15

seconds for the steam mop to heat up.

u Press the Autoselect

button (6) to the Wood/Laminate

setting.

u Pulling the handle (10) back will activate the steam pump.

After a few seconds steam will start to come out of the

steam head.

Note: When rst lled or after running dry it can take up to 45

seconds for steam to be produced.

u Push and pull the steam mop slowly across the carpet to

thoroughly refresh each section.

Note: During use you may turn off the steam pump by return-

ing the handle (10) to the upright position, this convenient

feature will allow you to place the steam mop on the resting

mat (13) so that you may move items of furniture with out the

need to switch the appliance off.

u When you have nished using the steam mop, return the

handle (10) to the upright position and turn it ‘OFF’, place

it on the resting mat (13) and wait until the steam mop

cools down. (approximately ve minutes)

Caution! If steam is observed escaping from the join between

the hand held steam cleaner and the steam mop body, switch

off and disconnect the unit from the mains supply. Allow to

cool. Remove the hand held steam cleaner from the steam

mop body. Inspect the seal (22) on the steam nozzle (4) and

hose (23) (g. H). If the seal is missing or damaged then

please contact your nearest authorised repair agent. Do not

use the appliance. If the seal is in good condition re-t the

hand held steam cleaner to the steam mop body ensuring that

it is seated rmly in place.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Black & Decker black&decker fsmh1621 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Nettoyeurs à vapeur Black & Decker black&decker fsmh1621