Black & Decker SNC100 Manuel d'instructions télécharger pdf (Page 2)

Installing The Wall Hook

Note: It is highly recommend to hang the Sweep and Collect on the provided hook or

similar device to prevent damage to the broom head.

Firmly attach the provided wall hook to the wall so it will not pull out. It should be mounted at

a minimum height of 54”(137 cm) to its’ bottom to ensure the broom head does not touch

the floor. (Fig. 8a) Use the hardware provided only if hanging on conventional hollow wall

construction such as sheetrock over studs. If not, use the appropriate fasteners for the

particular wall material.

Operation

WARNING: Do not use the Sweep and Collect without the dirt cup in place.

Note: The Sweep and Collect is to be used for pick up of dry debris on hard floors only.

Avoid picking up pieces of string and similar material to prevent binding of the beater bar.

How to Operate

• To change from sweep (Fig. 2) to collect mode (Fig. 3), push the button in the end of the

handle (Fig. 4a) and rotate the handle towards the broom bristles as shown in Fig. 4b.

At this point, the beater bar should start turning.

Note: During collection mode, the beater bar can be momentarily stopped by pushing the

button in the end of the handle.

• Roll the unit back and forth over the pile of debris to collect it into the dirt cup. For best pick

up performance, the broom head bristles should be facing away from the dirt pile as shown

above (Fig. 4c).

• To change back to sweep mode, rotate handle back into slot in housing (Fig. 5a) until it latches

(Fig. 5b) and you hear a “click” sound (Fig. 5c). To make it easier to return the handle to the sweep

position, the button in the end of the handle can be pressed. At this point, the beater bar should stop

t u r n i n g .

Emptying The Dirt Cup

Note: The unit needs to be in sweep mode (Fig. 2) before the dirt cup can be removed. It is

important not to use excessive force to remove the dirt cup. If the dirt cup seems stuck in

the housing, follow the “Unclogging the Unit” procedure.

1. Remove the dirt cup from unit by pulling straight up as shown. Do not push on

emptying button when pulling out. (Fig. 6a)

2. Hold the dirt cup over a garbage container and empty by completely depressing

emptying button and shaking moderately. (Fig. 6b)

3. Release the button and push the dirt cup back into the motorized dust pan until flush

with top surface.

Unclogging the Unit

Note: Dirt cup door mechanism must be free of debris to fully close and allow removal of the

dirt cup.

1. Remove batteries from the unit.

2. Rotate handle to change to collect mode. (Fig. 3)

3. Flip over to access the opening (Fig. 7) extending from the beater bar to the dirt cup.

4. Clean out any debris in this opening and at the entrance to the dirt cup that may impede

the operation of the beater bar or the dirt cup door mechanism.

5. Return to sweep mode.

6. Replace the batteries.

Maintaining the Beater Bar

Note: Periodic maintenance to the beater bar is required to ensure optimum pick up

p e r f o r m a n c e .

1. Remove the batteries from the unit.

2. Flip over to access the beater bar.

3. Remove any hair or other debris that is wrapped around or is trapped near the beater bar

to ensure it can rotate freely.

4. Replace the batteries.

Cleaning and Storage

• It is suggested that the dirt cup is emptied before storage.

• Hang unit on hook or other device when not in use to keep broom head in best condition

(Fig. 8a).

• Do not store the Sweep and Collect resting on the broom head (Fig. 8b) as this will result

in permanent damage to the bristles.

• Periodically clean the unit with a damp cloth, including the chamber which the dirt cup fits

into. Remove any hair, fiber or other materials that may have built up in the unit or on

the rotating brush.

• Don’t use abrasive materials to clean the sweeper. Do not immerse the unit in water.

Fig. 8a

Fig. 8b

“CLICK”

Fig. 5a

Fig. 5b

Fig. 5c

Opening

Fig. 6a

Fig. 6b

Fig. 7

54” min

137 cm

Fig. 4a

Fig. 4b

Fig. 4c

Sweep

Mode

Collect

Mode

Fig. 2

Fig. 3

TROUBLESHOOTING GUIDE

PROBLEM POSSIBLE REASON POSSIBLE SOLUTION

Motorized dust pan will not

operate

Motorized dust pan will not

pick-up

Motorized dust pan does not

roll smoothly on floor.

Dirt cup is difficult to remove /

replace

Brush roll will not turn off

1. Batteries depleted.

2. Button is depressed.

3. Handle is in sweep

position.

4. Unit needs servicing.

5. Beater bar jammed.

1. Dirt cup is full.

2. Batteries depleted.

3. Beater bar jammed or

clogged.

4. Unit clogged

1. Rollers are clogged with

debris.

1. Dirt build up in unit.

2. Obstruction in dirt path

has jammed dirt cup

door open.

3. Handle is in incorrect

position

1. Handle is not locked in

sweep position.

1. Install new alkaline batteries.

2. Release button.

3. Change to collect mode.

4. Call Customer Service.

5. Clean hair or debris from

beater bar.

1. Empty dirt cup.

2. Install new alkaline batteries.

3. Clean hair or debris from

beater bar.

4. Check for excessive material

on beater bar or in bottom of

sweeper. Follow “Unclogging

the Unit” and “Maintaining the

Beater Bar” instructions.

1. Position handle in sweep

mode to turn brush roll off.

Clean any hair/debris from

rollers (4), shafts and wheel

wells.

1. Remove dirt cup and

clean it and inside of unit with

damp cloth.

2. Check for excessive material

in bottom of sweeper. Follow

“Unclogging the Unit”

instructions.

3. Change to sweep mode.

1. Press handle into unit until

securely fitted.

Service Information

Black & Decker offers a full network of company-owned and authorized service locations

throughout North America. All Black & Decker Service Centers are staffed with trained

personnel to provide customers with efficient and reliable service.

Whether you need technical advice, repair, or genuine factory replacement parts, contact

the Black & Decker location nearest you.

To find your local service location, refer to the yellow page directory under “Tools—Electric”

or call: 1-800-54-HOW-TO.

Full Two-Year Home Use Warranty

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in

material or workmanship. The defective product will be replaced or repaired at no charge

in either of two ways:

The first, which will result in exchanges only, is to return the product to the retailer from

whom it was purchased (provided that the store is a participating retailer). Returns should

be made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days

after the sale). Proof of purchase may be required. Please check with the retailer for their

specific return policy regarding returns that are beyond the time set for exchanges. The

1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire

Black & Decker SNC100 Manuel d'instructions Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Non Black & Decker SNC100