Black & Decker VEC054D Manuel d'utilisateur

MAXX SSTTMCOMPACT POWER INVERTERINSTRUCTION MANUALThank you for choosing Black & Decker!Go to www.BlackandDecker.com/NewOwnerto register your new

3. At least three inches of clearance from other objects is maintained for cooling airflow;4. The unit is not exposed to direct heat, sunlight or to e

Permanent InstallationFor permanent installation to heavy-duty battery power you will need:• Two cables (as indicated in the “Specifications” section)

13. Connect the stripped, soldered (longer) end of the positive (+) cable to the red stud marked (+) on theinverter and tighten the retaining nut.14.

TROUBLESHOOTINGCommon Audio/Visual ProblemsResetting the UnitAfter over-voltage or thermal automatic shutdown, the VEC054D will reset automatically. T

CARE AND MAINTENANCEStorage1. Ideal storage temperature range is 50-68°F (10-20°C).2. Store and use the inverter in a cool, dry place with adequate ve

SPECIFICATIONSMaximum continuous power: 2000 wattsSurge capacity (peak power): 4000 wattsOutput voltage range: 105-125 voltsOutput frequency: 58-62 Hz

1GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCESREAD ALL INSTRUCTIONSWARNING: Read all instructions before operating product. Failure to f

• EXTENSION CORDS. Make sure your extension cord is in good condition. When using an extension cord, besure to use one heavy enough to carry the curre

3IMPORTANT CABLE INFORMATION:Substantial power loss and reduced battery operating time results from inverters installed with cables that arenot able t

• Overload and over-temperature shutdown activated if AC output exceeds rated watts• AC short-circuit shutdown• Low voltage audible alarm (sounds at 1

APPLIANCE POWER CONSUMPTIONMAXX SST™ inverters are ideal for powering:• Lights• TVs and TV/DVD (VCR) combinations units• Radio receivers/transceivers

Appliance Consumption in Amps and Watts Chart (continued)APPLIANCE AMPS@ WATTS@120VAC 120VAC10-Speed Blender 2.93 352Belt Sander 3.11 3743/8" Rev

safely operated. The equipment that needs the highest starting wattage are pumps and compressors that startunder load. This equipment can be safely te

Note: All operating time curves assume permanent installation with the appropriate DC input wire (See the“Specifications” section of this Instruction