Black & Decker LLP120 Manuel d'instructions télécharger pdf (Page 12)

being cut has been cut. If this does not occur, discontinue use of the

tool and remove the battery pack. Check if any debris is blocking

movement. To help in this process it may be necessary to remove

chain access cover(13). If on assembly the problem is still present

take the unit to a service center.



A high quality bar and chain oil or

SAE30 weight motor oil should be

used for chain and bar lubrication.

The use of a vegetable based bar

and chain oil is recommended when

pruning trees. Never use waste oil

or very thick oil. These may damage

your chain saw.

- Before first use and every ten

minutes of use you must oil the

product with the recommended

chain oil. Open the oiling cover

(4) and insert the bottle into the oil

filling hole (16) apply pressure to the bottle once to dispense oil.

- This should be adequate for about 10 minutes of cutting

depending upon cutting speed and type of wood.

- The hole feeds the oil through to the chain onto the chain bar

and an excessive amount of oil applied to the unit could mean the

oil drips from the unit around the jaw area. This is normal and is

nothing to be concerned about.



For your safety, this tool is equipped

with a double switching system.

This system prevents starting the

tool inadvertently.

A chain saw is intended for two-

handed use. Serious injury to the

operator, helpers, and/or bystanders

can result from one-handed

operation.



To open the handles, slide the latch (5)

backwards and pull the handles apart.

Ensure a firm grip on the handles and

then squeeze both switch actuators to

switch the unit on.

 Both switches must be

activated for the product to be used.

Do not force the tool - allow it to do

the work. It will do a better and safer job at the speed for which it is

designed. Excessive force will stretch the chain.

If the saw chain or bar becomes jammed:

- Switch the tool off.

- Remove the battery from the tool.

- Open the cut with wedges to relieve the strain on the guide bar.

Do not try to wrench the saw free. Start a fresh cut. After use, close

the handles and slide the latch (5) forward to the lock position. The

handles should be locked during transportation and storage.



- Make sure the tool is running at full speed before making a cut.

- Hold the tool firmly in place to avoid possible bouncing or

sideways movement of the tool.

- Guide the tool using light pressure.

- Always cut down from the top. This way you will avoid pinching

the saw chain.



Starting from branch tip reduce

the branch in logical steps cutting

off small sections. “When cutting a

limb that is under tension be aware

of spring back.

When the tension in the wood

fibres are released the spring

loaded limb may strike the operator

and /or throw the tool out of control”

- Remove the tool from the cut

while it is running at full speed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LLP120 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker LLP120