Black & Decker F990 Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 11
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
8
7
5. Al terminar, suelte el botón, coloque la plancha sobre el talón de descanso
y enchúfela. Permita que la plancha se caliente unos dos minutos hasta secar
toda el agua sobrante.
ALMACENAMIENTO DE LA PLANCHA
1. Desconecte la plancha y espere que se enfríe.
2. Verifique que el selector de tejidos esté ajustado a la posición “0”.
3. Enrolle el cable e insertelo en el enganche del enchufe
hasta que quede seguro en su lugar (M).
4. Almacene la plancha verticalmente sobre el talón de
descanso, a fin de evitar el goteo a través de la suela.
M
IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING.
Use iron only for its intended use.
To protect against a risk of electric shock, do not immerse the iron in
water or other liquids.
The iron should always be turned to “0” before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead grasp plug
and pull to disconnect.
Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around the iron when storing.
Always disconnect iron from electrical outlet when filling with water or
emptying and when not in use.
Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble
the iron, take it to a qualified serviceman for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is
used.
Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
Burns can occur from touching hot metal parts, hot water or steam. Use
caution when you turn a steam iron upside down - there may be hot
water in the reservoir.
SPECIAL INSTRUCTIONS
To avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
If an extension cord is absolutely necessary, a 15-ampere cord should be
used. Cords rated for less amperage may overheat. Care should be taken
to arrange the cord so that it cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS.
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire