Black & Decker ASI300 Manuel d'instructions télécharger pdf (Page 6)

SWITCH

The ON / OFF switch is located at the rear of the inflator just below

the storage compartment in the cavity that acts as a carrying

handle.

120v AC Mode

• Always fully extend the 120v AC cord before each use.

• To turn the inflator on, plug in the 120 volt cord and press the top

part of the switch marked “AC” (figure D).

• To turn the inflator off, partially depress the bottom part of the

switch marked “DC” to the “0” position.

12v DC Mode

WARNING! RISK OF UNSAFE OPERATION:

• Do not operate inflator when car engine is running.

• Always fully extend the 12v dc cord before each use.

• To turn the inflator on, plug the 12 volt adaptor into your vehicle’s 12

volt accessory socket and press the bottom part of the switch

marked “DC” (figure D).

• To turn the inflator off, partially depress the top part of the switch

marked “AC” to the “0” position.

HOSE AND CORD STORAGE

The hose and cords are stored in the storage compartment on top

of the Inflator. The holes in both sides of the cover allow for the hose

and cord to be out of the compartment so that the compartment

cover can be closed while the Inflator is in use. (figure E)

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the

tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized

service centers or other qualified service personnel, always using identical replacement

parts.

TROUBLESHOOTING

oblem Possible Cause Possible Solution

• Unit will not start. • Pressure setting may be • Adjust pressure setting

below the actual pressure. pointer to a higher setting.

• Fuse in 12 volt adaptor blown. • Replace adaptor and cord.

• Pointer is in contact with needle • Adjust pressure setting

indicator. pointer to a higher setting.

• Cord not plugged in. • Plug tool into a working

outlet.

• Circuit fuse is blown. • Replace circuit fuse.

(If the product repeatedly

causes the circuit fuse to

blow, discontinue use

immediately and have it

serviced at a Black &

Decker service center or

authorized servicer.)

494852-00 AS1300 inflator etc 8/9/06 10:38 AM Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Black & Decker ASI300 Manuel d'instructions Page 6

Commentaires sur ces manuels