Black & Decker V4820 Manuel d'utilisateur télécharger pdf (Page 6)

6

ENGLISH

Additional safety instructions for

batteries and chargers

Batteries

u Never attempt to open for any reason.

u Do not expose the battery to water.

u Do not expose the battery to heat.

u Do not store in locations where the

temperature may exceed 40 °C.

u Charge only at ambient temperatures

between 10 °C and 40 °C.

u Charge only using the charger

provided with the appliance/tool.

u When disposing of batteries, follow

the instructions given in the section

"Protecting the environment".

u Do not damage/deform the battery

pack either by puncture or impact, as

this may create a risk of injury and re.

u Do not charge damaged batteries.

u Under extreme conditions, battery

leakage may occur. When you notice

liquid on the batteries, proceed as

follows:

u Carefully wipe the liquid off using

a cloth. Avoid skin contact.

u In case of skin or eye contact, follow

the instructions below.

Warning! The battery uid may cause

personal injury or damage to property.

In case of skin contact, immediately rinse

with water. If redness, pain or irritation

occurs seek medical attention. In case of

eye contact, rinse immediately with clean

water and seek medical attention.

Chargers

Your charger has been designed for a

specic voltage. Always check that the

mains voltage corresponds to the voltage

on the rating plate.

Warning! Never attempt to replace the

charger unit with a regular mains plug.

u Use your Black & Decker charger

only to charge the battery in the

appliance/tool with which it was

supplied. Other batteries could burst,

causing personal injury and damage.

u Never attempt to charge non-

rechargeable batteries.

u If the supply cord is damaged, it must

be replaced by the manufacturer or an

authorised Black & Decker Service

Centre in order to avoid a hazard.

u Do not expose the charger to water.

u Do not open the charger.

u Do not probe the charger.

u The appliance/tool/battery must be

placed in a well ventilated area when

charging.

Electrical safety

Your charger has been designed for a

specic mains voltage. Always check that

the mains voltage corresponds to the

voltage on the rating plate.

#

Your charger is double

insulated.

Features

1. On/off switch

2. Release button

3. Dust bowl

Fig. A

4. Charging base

5. Charger

Installation

Fitting the charging base to the wall

The charging base can be tted to the

wall to provide a convenient storage and

charging point for the appliance.

Beforerstuse

Before rst use, the battery must be

charged for at least 24 hours.

Use

Chargingthebattery(g.D)

u Make sure that the appliance is

switched off. The battery will not be

charged with the on/off switch in the

on position.

u Place the appliance on the charging

base as shown.

u Plug in the charger.

u Switch on at the mains.

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Commentaires sur ces manuels

Pas de commentaire