Black & Decker NPT318 Manuel d'utilisateur télécharger pdf (Page 5)

capacity than 18 gauge. When using more than one extension to

make up the total length, be sure each extension contains at least

the minimum wire size.

CHART FOR MINIMUM WIRE SIZE (AWG) OF EXTENSION CORDS

NAMEPLATE RATING AMPS – 0 – 10.0

Total Extension Cord

Length (ft) 0-25 26-50 51-100 101-150

(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)

Wire Gauge 18 16 16 14

9. Use only the supplied charger when charging your unit. The use

of any other charger could damage the battery pack or create a

hazardous condition.

10. Use only one charger when charging.

11. Do not attempt to open the charger or the unit. There are no

customer serviceable parts inside. Return to any authorized Black

& Decker service center.

12. DO NOT incinerate battery packs even if they are severely

damaged or completely worn out.

13. Do not incinerate the batteries. They can explode in a fire. A small

leakage of liquid from the battery cells may occur under extreme

usage, charging or temperature conditions. This does not indicate

a failure. However, if the outer seal is broken and this leakage

gets on your skin:

a. Wash quickly with soap and water.

b. Neutralize with a mild acid such as lemon juice or vinegar.

c. If the battery liquid gets in your eyes, flush them with clean water

for a minimum of 10 minutes and seek immediate medical

attention. MEDICAL NOTE: The liquid is a 25-35% solution of

potassium hydroxide.

Charging the Battery

THE BATTERY PACK IS NOT FULLY CHARGED AT THE FACTORY.

CHARGE BATTERY PACK FOR AT LEAST 9 HOURS BEFORE USE.

The charger is designed to use standard household 120 volt 60 Hz

power.

1. Plug the charger into any standard 120 Volt

60 Hz electrical outlet (figure 1).

2. Slide the charger onto the battery pack as

shown in figure 2 and let the battery pack

charge initially for 9 hours. After the initial

charge, under normal usage, your battery

pack should be fully charged in 6 to 9 hours.

2a) During charging the green LED will appear.

2b) When charging is complete the green LED

will go off.

3. Unplug charger, and remove the battery pack.

Place the battery pack into the tool until it

“clicks” into place.

NOTE: To remove the battery pack, press

down on the release button on the back of

the battery pack and slide out (figure 3).

STORAGE RECOMMENDATION

1. Store tool:

a.) with the battery pack removed and on the charger.

b.) in a place that is cool and dry away from direct sunlight and

excess heat or cold.

c.) out of the reach of children.

2. For prolonged storage such as over the winter, the battery pack

should be fully charged and then removed from the charger. It

should be charged again just prior to use.

LEAVING THE BATTERY PACK IN THE CHARGER

It is OK to leave battery packs on charge for long periods of time.

The charger has a maintenance mode which gives the battery pack

enough charge to stay “topped off”. If however, the tool is not

expected to be needed for more than 30 days, unplug the charger

and store battery pack in a cool, dry location. NOTE: A battery pack

will lose its charge when kept off of the charger. If the battery pack

has not been kept on maintenance charge, it may need to be

recharged before use. A battery pack may also lose its charge if left

in a charger that is not plugged into an appropriate AC source.

1 2 3 4 5 6 7 8 9 10 ... 32 33

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPT318 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Black & Decker NPT318