Black & Decker NPS1018 Manuel d'instructions télécharger pdf (Page 9)

Operating the Power Scrubber

Connecting the Battery

• Unscrew the battery cover (2) counter-clockwise

from the Handle Module, 1/4 of a full revolution and then pull away

from handle.

• Insert the battery in the Handle, figure 19 and

be certain that it is fully into the handle cavity

until it “clicks” into place. Re-install the cover by

aligning the threads and screwing on in a

clockwise direction until firmly attached.

Transporting Power Scrubber

• Always remove the battery pack from the handle (figure 19) and

remove the brush (figure 8) when transporting the Power

Scrubber.

WARNING: Ensure that the Battery Cover is installed and fully

tightened. Failure to do so could allow water intrusion.

• To remove the battery, remove the cover as above, then press

down on the release button on the back of the battery (figure 20)

and slide out. Re-install the battery

cover.

The additional second center extension (C) (green connectors)

may not be included in all kits and is available as an accessory and

may be connected to the provided center extension (B) (orange).

The provided center extension has orange connectors. The

accessory center extension had green extensions. The orange

center extension may be connected to the handle, and the green

extension may be connected to the orange center extension The

green center extension WILL NOT fit into the Handle Module (A).

Disassembly

Detaching Modules

WARNING: To prevent accidental operation, insure that

battery is removed from the tool before performing the following

operations. Failure to do this could result in serious personal injury.

When detaching the modules, whether it is in the two, three or four

module mode, always detach the power head module first. To do this,

rest the handle module on the ground and grasp the center of the

power head module with one hand as show in figure 17. Use your

other hand to loosen the threaded sleeve as shown in figure 18 and

then pull the two halves apart. Repeat this process if the center

extensions were attached.

90513658 NPS1018 1/15/07 2:02 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Pas de commentaire

Black & Decker NPS1018 Manuel d'instructions Page 9