Black & Decker NPP2018 Manuel d'utilisateur télécharger pdf (Page 13)

If you try to cut off thick branches

from the bottom, the branch may

close in and pinch the saw chain

in the cut. If you try to cut off thick

branches from the top, without a

shallow undercut, the branch may

splinter figure 24.

Do not force Pole Saw. The motor

will overload and can burn out. It

will do the job better and safer at

the rate for which it was intended.

3. Remove Pole Saw from cut while

it is running at full speed. Stop Pole Saw by releasing trigger.

Make sure chain has stopped before setting Pole Saw down.

Saw chain sharpness

The cutters will dull immediately if they touch the ground or a nail

while cutting.

Saw chain tension

This should be done regularly. Refer to page 8 “Adjusting Chain

Tension”.

Pole Saw Maintenance Section

Regular maintenance ensures a long effective life for the tool.

After every 10 minutes of use be sure to remove the battery (be

aware the chain and bar can be hot!) check the bar and chain for

correct tension and lubricate per pole saw instruction manual.

Use only mild soap and damp cloth to clean the tool. Never let any

liquid get inside the tool; never immerse any part of the tool into a

liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs,

maintenance and adjustment should be performed by authorized

service centers or other qualified service organizations, always using

identical replacement parts.

Accessories

Replacement chain and bar are available from your nearest Black &

Decker service center.

Replacement chain # 623382-00, Replacement bar # 623381-00

The use of accessories not recommended in this manual may be

hazardous.

Troubleshooting Section

If your Pole Saw does not operate correctly check the following:

Problem

Possible Cause Possible Solution

• Tool will not

start.

• Unit will not

charge.

• Bar / chain

overheated.

• Battery not

installed properly.

• Battery not

charged.

• Lock-out button not

actuated.

• Pole connections

not properly

tightened.

• Battery not

inserted into

charger.

• Chain too tight.

• Lubrication

needed.

• Check battery installation.

• Check battery charging

requirements.

• Pull back on lock

button/actuate trigger.

• Refer to instruction manual

for pole connections.

• Insert battery into charger

until green LED appears.

Charge up to 9 hours if

battery totally drained.

• Refer to section on

adjusting chain tension.

• Refer to sections for chain

oiling application.

• Chain is

loose.

• Chain tension set

incorrectly.

• Refer to section for chain

tensioning.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NPP2018 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NPP2018