Black & Decker NLP1800 Manuel d'instructions télécharger pdf (Page 12)

Switching on and off (fig. J)

For your safety, this tool is equipped with a double switching

system. This system prevents starting the tool inadvertently.

A chain saw is intended for two-handed use. Serious injury to the

operator, helpers, and/or bystanders can result from one-handed

operation.

Switching on (fig. K)

To open the handles, slide the latch (5) backwards and pull the

handles apart. Ensure a firm grip on the handles and then squeeze

both switch actuators to switch the unit on.

Note: Both switches must be activated for the product to be used.

Do not force the tool - allow it to do the work. It will do a better and

safer job at the speed for which it is designed. Excessive force will

stretch the chain.

If the saw chain or bar becomes jammed:

- Switch the tool off.

- Remove the battery from the tool.

- Open the cut with wedges to relieve the strain on the guide bar.

Do not try to wrench the saw free. Start a fresh cut.

After use, close the handles and slide the latch (5) forward to the

lock position. The handles should be locked during transportation

and storage.

Trimming branches

- Make sure the tool is running at full speed before making a cut.

- Hold the tool firmly in place to avoid possible bouncing or

sideways movement of the tool.

- Guide the tool using light pressure.

- Always cut down from the top. This way you will avoid pinching

the saw chain.

- Remove branches as shown in Fig L. Starting from branch tip

reduce the branch in logical steps cutting off small sections. “When

cutting a limb that is under tension be aware of spring back.

- When the tension in the wood fibres are released the spring

loaded limb may strike the operator and /or throw the tool out of

control”

- Remove the tool from the cut while it is running at full speed.

Maintenance

Your Black & Decker tool has been designed to operate over a long

period of time with a minimum of maintenance. Continuous satisfactory

operation depends upon proper tool care and regular cleaning.

WARNING: Before performing any maintenance or cleaning of

the tool, remove battery from the tool.

Cleaning

- Regularly remove the chain access cover and remove any debris

that has become trapped.

- Regularly clean the ventilation slots with a clean, dry paint brush.

- To clean the tool, use only mild soap and a damp cloth. Never let

any liquid get inside the tool and never immerse any part of the tool

into liquid.

Oiling

- Regularly oil the oiling points (16) as indicated in figure I.

Transporting

- Always transport the tool with the jaws closed and the latch in the

locked position.

Saw Chain Sharpening

CAUTION: Sharp chain. Always wear protective gloves when

handling the chain. The chain is sharp and can cut you when it is

not running.

WARNING: Sharp moving chain. To prevent accidental

operation, insure that battery is disconnected from the tool

before performing the following operations. Failure to do this

could result in serious personal injury.

To get the best possible performance from your chain saw it is

important to keep the teeth of the chain sharp. Follow these helpful

tips for proper saw chain sharpening:

1. Remove the saw chain and use a chain vise when doing any

sharpening. See “Removing the saw chain and chain bar”.

2. For best results use a 4.5mm file and a file holder or filing guide

to sharpen your chain. This will ensure you always get the correct

sharpening angles.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 45 46

Commentaires sur ces manuels

Pas de commentaire

Black & Decker NLP1800 Manuel d'instructions Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker NLP1800