Black & Decker LH1600 Manuel d'instructions télécharger pdf (Page 9)

any obstruction that your saw chain could hit while you ar

cutting through a particular log or branch.

(10.) Keep your saw chain sharp and properly tensioned. A

loose or dull chain can increase the chance of kickback

Check tension at regular intervals with the motor stopped

never with the motor running.

(11.) Begin and continue cutting only with the chain moving a

full speed. If the chain is moving at a slower speed, there is

greater chance for kickback to occur.

(12.) Cut one log at a time.

(13.) Use extreme caution when re-entering a previous c

Engage spiked bumpers into wood and allow chain to reach f

speed before proceeding with cut.

(14.) Do not attempt plunge cuts or bore cuts.

(15.) Watch for shifting logs or other forces that could close

cut and pinch or fall into chain.

• Power Supply

Connect chain saw to correct voltage, that is, be sure that t

voltage supplied is the same as that specified on th

nameplate of the tool.

Kickback Safety Features

Warning: The following features are included on your sa

to help reduce the hazard of kickback; however such featur

will not totally eliminate this dangerous reaction. As a cha

saw user do not rely only on safety devices. You must follo

all safety precautions, instructions, and maintenance in th

manual to help avoid kickback and other forces which c

result in serious injury.

• Reduced-Kickback Guide Bar, designed with a sm

radius tip which reduces the size of the kickback danger zo

on bar tip. A reduced- kickback guide bar is one which h

assembled. Be sure that the saw chain stops moving when the

trigger is released.

• Guard Against Kickback

WARNING: KICKBACK may occur when the nose or tip of

the guide bar touches an object, or when the wood closes in

and pinches the saw chain in the cut. Tip contact in some

cases may cause a lightning fast reverse reaction, kicking the

guide bar up and back towards the operator. Pinching the saw

chain along the top of the guide bar may push the guide bar

rapidly back towards the operator. Either of these reactions

may cause you to lose control of the saw which could result in

serious injury to user.

The following precautions should be followed to minimize

kickback:

(1.) Grip Saw Firmly.

Hold the chain saw firmly with both hands when the motor is

running. Use a firm grip with thumbs and fingers encircling the

chain saw handles.

(2.) Do not over reach.

(3.) Keep proper footing and balance at all times.

(4.) Don't let the nose of the guide bar contact a log, branch,

ground or other obstruction.

(5.) Don't cut above shoulder height.

(6.) Use devices such as low kickback chain, chain braking

system and special guide bars that reduce the risks associated

with kickback.

(7.) Only use replacement bars and chains specified by the

manufacturer or the equivalent.

(8.) Never let the moving chain contact any object at the tip of

the guide bar.

(9.) Keep the working area free from obstructions such as other

trees, branches, rocks, fences, stumps, etc. Eliminate or avoid

If you have any questions, call 1-800-54-HOW-T

chainsaw booklet 1/19/00 1:45 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Black & Decker LH1600 Manuel d'instructions Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Black & Decker LH1600